Shafer soil
Wild-clay potential
Strong lead
Strong lead: a clay-enriched layer typically about 7 to 18 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Shafer soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Rated from the USDA soil survey record for Shafer-Hann complex, 2 to 35 percent slopes (Ada County, Idaho) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Raises the potential Clayey layer: about 55% clay in the fine-earth portion.
- Note USDA labels this a "Btss1" horizon: a subsoil layer where clay has accumulated.
- Raises the potential High engineering plasticity index (40): USDA's estimate suggests plastic behavior when wet.
- Raises the potential The official series description calls the wet soil very sticky and very plastic (a field observation, not a ceramic test).
- Note Moderate thickness (about 11 in (28 cm)).
- Note Typically starts within about 7 in (18 cm) of the surface.
- Note Few rock fragments (about 0% by volume).
- Note High shrink-swell (linear extensibility about 12.1%): often very plastic, and prone to cracking as it dries.
- Note Engineering class CH: a clay of high plasticity in the Unified system.
Layer by layer
- Clay-rich layerA A clay loam layer about 0 to 1 in down: about 38% clay, high plasticity when wet, dark reddish gray when moist. Possible
- Clay-rich layerBA A clay layer about 1 to 7 in down: about 45% clay, high plasticity when wet, dark reddish gray when moist. Strong lead
- Clay subsoilBtss1best layer A clay layer about 7 to 18 in down: about 55% clay, high plasticity when wet, dark reddish gray when moist. Strong lead
- Clay subsoilBtss2 A clay loam layer about 18 to 22 in down: about 36% clay, high plasticity when wet, brown when moist. Promising
- BedrockCrt Bedrock about 22 to 25 in down: no clay layer to dig. Weak indication
- BedrockR Bedrock about 25 to 35 in down: no clay layer to dig. Weak indication
What it looks like raw
The clay subsoil (Btss1), 7 to 18 in down in the typical profile: dark reddish gray (5YR 4/2), dark reddish brown (5YR 3/2) moist; extremely hard, very firm, very sticky and very plastic. Raw colour is not fired colour.
About the soil
- Parent material: clayey lacustrine deposits and/or colluvium derived from welded tuff and/or basalt over welded tuff.
- USDA family mineralogy: smectitic. Smectite-rich clays are usually very plastic and shrink a lot as they dry.
- USDA family particle-size class: fine.
- Drainage: well drained.
- Lithic bedrock typically about 25 in (64 cm) down.
Where it is mapped
Seen on the map as the most common soil in 3 map units in Idaho, in these survey areas: Ada County, Idaho; Boise County Area, Idaho, Western Part.
By state: wild clay in Idaho.
USDA, distribution and extent: West-central Idaho. MLRA 10. Shafer soils are not extensive.
USDA, geographic setting: Shafer soils are on structural benches, hill summits, and footslopes of hills and butte escarpments at elevations of 2,700 to 5,250 feet. Slopes range from 4 to 35 percent. These soils formed in colluvium and residuum from welded tuff and basalt mixed with lacustrine deposits. The average annual precipitation is 14 to 20 inches. The average annual temperature is 45 to 50 degrees F. The frost-free period is 90 to 140 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Aradaran: Strong lead
- Hann: Strong lead
- McDesh: Strong lead
- Aldape: Strong lead
- Bowns: Strong lead
- Breadloaf: Strong lead
- Brent: Strong lead
- Castlerock: Strong lead
See it on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 55%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
- Parts of the Official Series Description could not be interpreted; open the original for the complete text.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Shafer-Hann complex, 2 to 35 percent slopes, map unit 6004 in Ada County, Idaho.
- Official Series Description: Shafer(revised 06/2006), established.
- Taxonomic class: Fine, smectitic, mesic Leptic Haploxererts
- Rated with rule version 2026-09-28.1; the method is on the About page.