Ralph soil
Wild-clay potential
Promising
Promising: a loamy layer with some clay typically about 17 to 34 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Ralph soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Rated from the USDA soil survey record for Ralph loam, 3 to 6 percent slopes (Butte County, South Dakota) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Raises the potential Clay-enriched layer: about 28% clay in the fine-earth portion.
- Note Moderate engineering plasticity index (16).
- Note The official series description calls the wet soil slightly sticky and slightly plastic.
- Note Thick enough to investigate (about 17 in (43 cm)).
- Note Typically starts within about 17 in (43 cm) of the surface.
- Missing data Rock fragment content is not reported.
- Note USDA reports about 9% calcium carbonate; lime in a clay body deserves testing.
Layer by layer
- Loamy layerH1 A loam layer about 0 to 6 in down: about 21% clay, moderate plasticity when wet, grayish brown when moist. Possible
- Loamy layerH2 A clay loam layer about 6 to 17 in down: about 28% clay, moderate plasticity when wet, grayish brown when moist. Promising
- Loamy layerH3best layer A clay loam layer about 17 to 34 in down: about 28% clay, moderate plasticity when wet, light brownish gray when moist. Promising
- BedrockCr Weathered bedrock about 34 to 60 in down: no clay layer to dig. Weak indication
What it looks like raw
The loamy layer (H3), 17 to 34 in down in the typical profile: light brownish gray (2.5Y 6/2), olive brown (2.5Y 4/4) moist; hard, firm, slightly sticky and slightly plastic. Raw colour is not fired colour.
About the soil
- Parent material: residuum weathered from sedimentary rock.
- USDA family mineralogy: mixed.
- USDA family particle-size class: fine-silty.
- Drainage: well drained.
- Paralithic bedrock typically about 30 in (77 cm) down.
Where it is mapped
Seen on the map as the most common soil in 1 map unit in South Dakota, in these survey areas: Butte County, South Dakota.
By state: wild clay in South Dakota.
USDA, distribution and extent: Northwestern South Dakota. The series is of small extent.
USDA, geographic setting: Ralph soils are on nearly level, undulating and rolling uplands. Slope gradients range from 0 to 9 percent. Ralph soils formed in silty material weathered from calcareous silty shales, siltstone or fine grained sandstone. Mean annual temperature ranges from 39 to 45 degrees F, and mean annual precipitation ranges from 14 to 15 inches.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Absher: Strong lead
- Arvada: Strong lead
- Belfield: Strong lead
- Bidman: Strong lead
- Hisle: Strong lead
- Kyle: Strong lead
- McKenzie: Strong lead
- Pierre: Strong lead
See it on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 80%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Ralph loam, 3 to 6 percent slopes, map unit RaB in Butte County, South Dakota.
- Official Series Description: Ralph, established.
- Taxonomic class: Fine-silty, mixed, superactive, frigid Aridic Argiustolls
- Rated with rule version 2026-09-28.1; the method is on the About page.