Pope soil
Wild-clay potential
Weak indication
Weak indication: no layer of Pope shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Pope soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Rated from the USDA soil survey record for Pope loam, 0 to 3 percent slopes, occasionally flooded (Venango County, Pennsylvania) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Lowers the potential Too little clay to be a clay body on its own: about 7% clay.
- Lowers the potential Low engineering plasticity index (4): little plastic behavior expected when wet.
- Note Thick enough to investigate (about 48 in (122 cm)).
- Note Typically starts about 32 in (81 cm) down; expect real digging or look for cuts and banks.
- Lowers the potential Noticeable rock fragments (about 25% by volume); screening would be needed and the clay percentage applies to the fine earth only.
Layer by layer
- Organic top layerOi An organic top layer about 0 to 2 in down, not a clay body. Weak indication
- Organic top layerOe An organic top layer about 2 to 3 in down, not a clay body. Weak indication
- TopsoilA A loam layer about 3 to 7 in down: about 15% clay, moderate plasticity when wet, brown when moist. Weak indication
- Sandy layerBw1 A fine sandy loam layer about 7 to 22 in down: about 10% clay, low plasticity when wet, dark yellowish brown when moist. Weak indication
- Sandy layerBw2 A fine sandy loam layer about 22 to 32 in down: about 10% clay, low plasticity when wet, dark yellowish brown when moist. Weak indication
- Sandy layerCbest layer A gravelly fine sandy loam layer about 32 to 80 in down: about 7% clay, low plasticity when wet, dark yellowish brown when moist. Weak indication
What it looks like raw
The sandy layer (C), 32 to 80 in down in the typical profile: dark yellowish brown (10YR 4/4); fine sandy loam; loose. Raw colour is not fired colour.
About the soil
- Parent material: acid coarse-loamy alluvium derived from sandstone and shale.
- USDA family mineralogy: mixed.
- USDA family particle-size class: coarse-loamy.
- Drainage: well drained.
Where it is mapped
Seen on the map as the most common soil in 4 map units in Pennsylvania, in these survey areas: Lebanon County, Pennsylvania; Schuylkill County, Pennsylvania; Venango County, Pennsylvania; Warren and Forest Counties, Pennsylvania.
By state: wild clay in Pennsylvania.
USDA, distribution and extent: Pope soils are found mainly in MLRAs 124, 125, 126, 128, 130B, and 147 consisting of mountain and plateau areas of Kentucky, Maryland, Ohio, Pennsylvania, Tennessee, Virginia, and West Virginia. Pope soils are also mapped less extensively in Alabama, Indiana, New Jersey and New York in MLRA's 114, 140 and 148. The extent is large.
USDA, geographic setting: Pope soils are on flood plains with slopes mainly less than 4 percent. They formed in alluvium weathered from acid sandstone, siltstone, and shale. Average annual air temperature ranges from 8.5 to 14 degrees C and the average annual precipitation from 1065 to 1370 millimeters.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Cavode: Strong lead
- Armagh: Strong lead
- Hagerstown: Strong lead
- Watchung: Strong lead
- Brinkerton: Promising
- Ernest: Promising
- Shelmadine: Promising
- Wharton: Promising
See it on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 85%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Pope loam, 0 to 3 percent slopes, occasionally flooded, map unit Po in Venango County, Pennsylvania.
- Official Series Description: Pope(revised 04/2025), established.
- Taxonomic class: Coarse-loamy, mixed, active, mesic Fluventic Dystrudepts
- Rated with rule version 2026-09-28.1; the method is on the About page.