Picayune soil
Wild-clay potential
Weak indication
Weak indication: no layer of Picayune shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Picayune soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Picayune spot on the map
Rated from the USDA soil survey record for Agassiz association, very steep (Salt Lake Area, Utah) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Note Loamy layer with some clay: about 22% clay. It may need settling or refining to become a clay body.
- Note Moderate engineering plasticity index (12.5).
- Raises the potential The official series description calls the wet soil slightly sticky and moderately plastic (a field observation, not a ceramic test).
- Note Thick enough to investigate (about 18 in (46 cm)).
- Note Typically starts within about 0 in (0 cm) of the surface.
- Lowers the potential Noticeable rock fragments (about 29% by volume); screening would be needed and the clay percentage applies to the fine earth only.
- Lowers the potential Surface layer with about 3.5% organic matter; roots and organics complicate use.
Layer by layer
- TopsoilA11best layer A gravelly loam layer about 0 to 18 in down: about 22% clay, moderate plasticity when wet, pale brown when moist. Weak indication
- TopsoilA12 A gravelly loam layer about 18 to 26 in down: about 25% clay, moderate plasticity when wet, pale brown when moist. Weak indication
- Loamy layerC1 A very gravelly loam layer about 26 to 32 in down: about 25% clay, moderate plasticity when wet, pale brown when moist. Weak indication
- Loamy layerC2 A very gravelly clay loam layer about 32 to 50 in down: about 31% clay, moderate plasticity when wet, light gray when moist. Weak indication
- Sandy layerC3 A very gravelly sandy loam layer about 50 to 60 in down: about 15% clay, moderate plasticity when wet, light gray when moist. Weak indication
What it looks like raw
The topsoil (A11), 0 to 18 in down in the typical profile: pale brown (10YR 6/3), brown (10YR 4/3) moist; hard, firm, slightly sticky, plastic. Raw colour is not fired colour.
About the soil
- Parent material: colluvium derived from limestone and shale and/or residuum weathered from limestone and shale.
- USDA family mineralogy: mixed.
- USDA family particle-size class: fine-loamy.
- Drainage: well drained.
Where it is mapped
Seen on the map as the most common soil in 1 map unit in Utah, in these survey areas: Salt Lake Area, Utah.
By state: wild clay in Utah.
USDA, distribution and extent: These soils are inextensive and important for watershed and grazing along the Wasatch Front in north-central Utah.
USDA, geographic setting: Picayune soils occur at elevations of 5,200 to 7,200 feet above sea level on steep or very steep mountain slopes with gradients of 15 to 70 percent slopes. These soils formed in medium textured colluvium or local alluvium derived mainly from limestone parent rocks. The climate is moist subhumid having mean annual temperatures of about 43 to 45 degrees F., an average summer temperature of 62 to 65 degrees F. and an average annual precipitation of 18 to 20 inches. PRINCIPAL ASSOCIATED SOILS: These are the Dry Creek. Henefer and Rake soils. Dry Creek soils have cobbly clay B2t horizons and calcic horizons. Henefer soils have cobbly clay B2t horizons. Rake soils have very cobbly Bt horizons...
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Bramwell: Strong lead
- Deckerman: Strong lead
- Eimarsh: Strong lead
- Jordan: Strong lead
- Lasil: Strong lead
- Magna: Strong lead
- Pintailake: Strong lead
- Saltair: Strong lead
See it on the map
Open a Picayune spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 55%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Agassiz association, very steep, map unit AGG in Salt Lake Area, Utah.
- Official Series Description: Picayune(revised 03/2003), established.
- Taxonomic class: Fine-loamy, mixed, superactive, frigid Calcic Haploxerolls
- Rated with rule version 2026-09-28.1; the method is on the About page.