Peshastin soil
Wild-clay potential
Weak indication
Weak indication: no layer of Peshastin shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Peshastin soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Peshastin spot on the map
Rated from the USDA soil survey record for Peshastin stony fine sandy loam, 30 to 60 percent slopes (Douglas County, Washington) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Lowers the potential Too little clay to be a clay body on its own: about 4% clay.
- Lowers the potential Low engineering plasticity index (2.5): little plastic behavior expected when wet.
- Lowers the potential The official series description calls the wet soil nonsticky and nonplastic.
- Note Thick enough to investigate (about 40 in (101 cm)).
- Note Typically starts within about 20 in (51 cm) of the surface.
- Lowers the potential High rock content (about 49% by volume) lowers its practical promise; the clay percentage applies only to the fine earth between the rocks.
- Note USDA reports about 5% calcium carbonate; lime in a clay body deserves testing.
Layer by layer
- Sandy layerH1 A stony fine sandy loam layer about 0 to 9 in down: about 8% clay, low plasticity when wet, grayish brown when moist. Weak indication
- Sandy layerH2 A cobbly sandy loam layer about 9 to 20 in down: about 8% clay, low plasticity when wet, brown when moist. Weak indication
- Sandy layerH3best layer An extremely cobbly sandy loam layer about 20 to 60 in down: about 4% clay, low plasticity when wet, light brownish gray when moist. Weak indication
What it looks like raw
The sandy layer (H3), 20 to 60 in down in the typical profile: light brownish gray (10YR 6/2), dark grayish brown (10YR 4/2) moist; slightly hard, very friable, nonsticky and nonplastic. Raw colour is not fired colour.
About the soil
- Parent material: loess mixed with glacial outwash and ablation till.
- USDA family mineralogy: mixed.
- USDA family particle-size class: loamy-skeletal.
- Drainage: well drained.
Where it is mapped
Seen on the map as the most common soil in 1 map unit in Washington, in these survey areas: Douglas County, Washington.
By state: wild clay in Washington.
USDA, distribution and extent: North central Washington. Series is of small extent.
USDA, geographic setting: Peshastin soils are on glacial moraines and terraces. These soils formed in glacial outwash and ablation glacial till derived mainly from granite, schist, gneiss, and sandstone with a component of loess and volcanic ash in the surface. Some ice-rafted deposits also occur. Slopes are 0 to 60 percent. Elevations range from 700 to 2,400 feet. The climate is characterized by hot, dry summers and cool, moist winters. The average annual precipitation is 8 to 12 inches. The mean January temperature is about 28 degrees F, mean July temperature is about 74 degrees F, and the mean annual temperature is about 50 degrees F. The frost-free period is 140 to 190 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Cashmere: Weak indication
- Cashmont: Weak indication
- Entiat: Weak indication
- Kiona: Weak indication
- Logy: Weak indication
- Pogue: Weak indication
- Quincy: Weak indication
- Bellingham: Strong lead(same state)
See it on the map
Open a Peshastin spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 85%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Peshastin stony fine sandy loam, 30 to 60 percent slopes, map unit 260 in Douglas County, Washington.
- Official Series Description: Peshastin, established.
- Taxonomic class: Loamy-skeletal, mixed, superactive, mesic Calcidic Haploxerolls
- Rated with rule version 2026-09-28.1; the method is on the About page.