Kiona soil
Wild-clay potential
Weak indication
Weak indication: no layer of Kiona shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Kiona soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Rated from the USDA soil survey record for Kiona-Rock outcrop complex, 25 to 65 percent slopes (Douglas County, Washington) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Lowers the potential Too little clay to be a clay body on its own: about 9% clay.
- Lowers the potential Low engineering plasticity index (2.5): little plastic behavior expected when wet.
- Note The official series description calls the wet soil slightly sticky and slightly plastic.
- Note Thick enough to investigate (about 41 in (104 cm)).
- Note Typically starts within about 19 in (48 cm) of the surface.
- Lowers the potential High rock content (about 46% by volume) lowers its practical promise; the clay percentage applies only to the fine earth between the rocks.
Layer by layer
- Sandy layerH1 A stony very fine sandy loam layer about 0 to 3 in down: about 10% clay, low plasticity when wet, grayish brown when moist. Weak indication
- Sandy layerH2 A cobbly very fine sandy loam layer about 3 to 19 in down: about 11% clay, low plasticity when wet, brown when moist. Weak indication
- Sandy layerH3best layer A very cobbly sandy loam layer about 19 to 60 in down: about 9% clay, low plasticity when wet, light brownish gray when moist. Weak indication
What it looks like raw
The sandy layer (H3), 19 to 60 in down in the typical profile: light brownish gray (10YR 6/2) dry, dark grayish brown (10YR 4/2) moist; soft, very friable, slightly sticky and slightly plastic. Raw colour is not fired colour.
About the soil
- Parent material: loess mixed with colluvium weathered from basalt.
- USDA family mineralogy: mixed.
- USDA family particle-size class: loamy-skeletal.
- Drainage: well drained.
Where it is mapped
Seen on the map as the most common soil in 1 map unit in Washington, in these survey areas: Douglas County, Washington.
By state: wild clay in Washington.
USDA, distribution and extent: Central Washington; MLRAs 7 and 8; moderate extent
USDA, geographic setting: Elevation--60 to 760 m
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Cashmere: Weak indication
- Cashmont: Weak indication
- Entiat: Weak indication
- Logy: Weak indication
- Peshastin: Weak indication
- Pogue: Weak indication
- Quincy: Weak indication
- Bellingham: Strong lead(same state)
See it on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 50%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Kiona-Rock outcrop complex, 25 to 65 percent slopes, map unit 214 in Douglas County, Washington.
- Official Series Description: Kiona(revised 12/2022), established.
- Taxonomic class: Loamy-skeletal, mixed, superactive, mesic Xeric Haplocambids
- Rated with rule version 2026-09-28.1; the method is on the About page.