Cashmont soil
Wild-clay potential
Weak indication
Weak indication: no layer of Cashmont shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Cashmont soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Cashmont spot on the map
Rated from the USDA soil survey record for Cashmont sandy loam, 0 to 3 percent slopes (Chelan County Area, Washington (Parts of Chelan and Kittitas Counties)) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Lowers the potential Too little clay to be a clay body on its own: about 9% clay.
- Lowers the potential Low engineering plasticity index (2.5): little plastic behavior expected when wet.
- Lowers the potential The official series description calls the wet soil nonsticky and nonplastic.
- Note Thick enough to investigate (about 39 in (99 cm)).
- Note Typically starts within about 21 in (53 cm) of the surface.
- Lowers the potential Noticeable rock fragments (about 27% by volume); screening would be needed and the clay percentage applies to the fine earth only.
Layer by layer
- Sandy layerH1 A sandy loam layer about 0 to 8 in down: about 9% clay, low plasticity when wet, grayish brown when moist. Weak indication
- Sandy layerH2 A gravelly sandy loam layer about 8 to 21 in down: about 9% clay, low plasticity when wet, brown when moist. Weak indication
- Sandy layerH3best layer A gravelly sandy loam layer about 21 to 60 in down: about 9% clay, low plasticity when wet, yellowish brown when moist. Weak indication
What it looks like raw
The sandy layer (H3), 21 to 60 in down in the typical profile: yellowish brown (10YR 5/4), dark yellowish brown (10YR 3/4) moist; soft, very friable, nonsticky and nonplastic. Raw colour is not fired colour.
About the soil
- Parent material: alluvium, glaciofluvial deposits or ablation till.
- USDA family mineralogy: mixed.
- USDA family particle-size class: coarse-loamy.
- Drainage: well drained.
Where it is mapped
Seen on the map as the most common soil in 6 map units in Washington, in these survey areas: Chelan County Area, Washington (Parts of Chelan and Kittitas Counties); Douglas County, Washington.
By state: wild clay in Washington.
USDA, distribution and extent: North-central Washington; MLRA 8. They are of moderate extent.
USDA, geographic setting: Cashmont soils are on alluvial fans, till plains, and terraces. Slope ranges from 0 to 45 percent. The soils formed in glacial till, glaciofluvial, or alluvial deposits of mixed mineralogy. Elevations are of 700 to 1,800 feet. They occur in a climate with hot, dry summers and cool, moist winters. The mean annual precipitation is 8 to 12 inches. The mean January temperature is 22 degrees F, mean July temperature is 73 degrees F, mean annual temperature is 48 to 51 degrees F. The frost-free season is 140 to 190 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Bjork: Promising
- Peoh: Promising
- Cowiche: Possible
- Morical: Possible
- Zen: Possible
- Entiat: Weak indication
- Pogue: Weak indication
- Quincy: Weak indication
See it on the map
Open a Cashmont spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 100%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Cashmont sandy loam, 0 to 3 percent slopes, map unit CcA in Chelan County Area, Washington (Parts of Chelan and Kittitas Counties).
- Official Series Description: Cashmont(revised 09/2007), established.
- Taxonomic class: Coarse-loamy, mixed, superactive, mesic Aridic Haploxerolls
- Rated with rule version 2026-09-28.1; the method is on the About page.