Peoh soil
Wild-clay potential
Promising
Promising: a loamy layer with some clay typically about 32 to 60 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Peoh soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Rated from the USDA soil survey record for Peoh silt loam (Chelan County Area, Washington (Parts of Chelan and Kittitas Counties)) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Raises the potential Clay-enriched layer: about 28% clay in the fine-earth portion.
- Note Moderate engineering plasticity index (15).
- Note Thick enough to investigate (about 28 in (71 cm)).
- Note Typically starts about 32 in (81 cm) down; expect real digging or look for cuts and banks.
- Missing data Rock fragment content is not reported.
Layer by layer
- Loamy layerH1 A silt loam layer about 0 to 16 in down: about 23% clay, moderate plasticity when wet, grayish brown when moist. Possible
- Loamy layerH2 A clay loam layer about 16 to 32 in down: about 28% clay, moderate plasticity when wet, grayish brown when moist. Promising
- Loamy layerH3best layer A sandy clay loam layer about 32 to 60 in down: about 28% clay, moderate plasticity when wet, grayish brown when moist. Promising
What it looks like raw
The loamy layer (H3), 32 to 60 in down in the typical profile: grayish brown (10YR 5/2). Raw colour is not fired colour.
About the soil
- Parent material: alluvium.
- USDA family mineralogy: mixed.
- USDA family particle-size class: fine-loamy.
- Drainage: poorly drained.
- Rated hydric (wetland) soil; often saturated and protected.
Where it is mapped
Seen on the map as the most common soil in 1 map unit in Washington, in these survey areas: Chelan County Area, Washington (Parts of Chelan and Kittitas Counties).
By state: wild clay in Washington.
USDA, distribution and extent: North central Washington. Peoh soils are of small extent.
USDA, geographic setting: These soils occupy nearly level and gently sloping meadowlike areas in the uplands; slope gradients range from 0 to 8 percent. Peoh soils formed in mixed alluvium. There is some loess and volcanic ash mixed in the surface layer of the soils and this overlies older heavier textured alluvium. The soils occur at elevations of 800 to 1,500 feet in a subhumid climate; the mean annual temperature is 46 to 50 degrees F.; the average annual precipitation is 15 to 25 inches; and the frost free season is 130 to 165 days. PRINCIPAL ASSOCIATED SOILS: These are the Leavenworth and Brief soils. Both of these soils are well drained.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Bjork: Promising
- Cowiche: Possible
- Morical: Possible
- Zen: Possible
- Anatone: Weak indication
- Ardenvoir: Weak indication
- Beverly: Weak indication
- Billyridge: Weak indication
See it on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 100%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Peoh silt loam, map unit Pe in Chelan County Area, Washington (Parts of Chelan and Kittitas Counties).
- Official Series Description: Peoh(revised 05/2001), established.
- Taxonomic class: Fine-loamy, mixed, superactive, mesic Cumulic Endoaquolls
- Rated with rule version 2026-09-28.1; the method is on the About page.