Billyridge soil
Wild-clay potential
Weak indication
Weak indication: no layer of Billyridge shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Billyridge soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Billyridge spot on the map
Rated from the USDA soil survey record for Billyridge gravelly sandy loam, 0 to 8 percent slopes (Cashmere Mountain Area, Washington, Parts of Chelan and Okanogan Counties) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Lowers the potential Too little clay to be a clay body on its own: about 9% clay.
- Lowers the potential Low engineering plasticity index (2.5): little plastic behavior expected when wet.
- Lowers the potential The official series description calls the wet soil nonsticky and nonplastic.
- Note Thick enough to investigate (about 24 in (61 cm)).
- Note Typically starts within about 16 in (41 cm) of the surface.
- Lowers the potential Noticeable rock fragments (about 21% by volume); screening would be needed and the clay percentage applies to the fine earth only.
Layer by layer
- Sandy layerH1 A gravelly sandy loam layer about 0 to 16 in down: about 9% clay, low plasticity when wet, grayish brown when moist. Weak indication
- Sandy layerH2best layer A gravelly sandy loam layer about 16 to 40 in down: about 9% clay, low plasticity when wet, brown when moist. Weak indication
- Sandy layerH3 A gravelly sandy loam layer about 40 to 60 in down: about 9% clay, low plasticity when wet, pale brown when moist. Weak indication
What it looks like raw
The sandy layer (H2), 16 to 40 in down in the typical profile: brown (10YR 5/3), dark brown (10YR 4/3) moist; soft, friable, nonsticky and nonplastic. Raw colour is not fired colour.
About the soil
- Parent material: alluvium.
- USDA family mineralogy: mixed.
- USDA family particle-size class: coarse-loamy.
- Drainage: well drained.
Where it is mapped
Seen on the map as the most common soil in 5 map units in Washington, in these survey areas: Cashmere Mountain Area, Washington, Parts of Chelan and Okanogan Counties; Chelan County Area, Washington (Parts of Chelan and Kittitas Counties).
By state: wild clay in Washington.
USDA, distribution and extent: Valleys in northcentral Washington. This series is of small extent.
USDA, geographic setting: Billyridge soils are on fans and terraces and have slopes of 0 to 25 percent slopes. The soils formed in alluvium. Elevation is 1,100 to 1,700 feet. These soils developed in a climate with warm, dry summers and cool, moist winters. The average annual precipitation is 18 to 24 inches. The mean January temperature is about 24 degrees F and the mean July temperature is about 69 degrees F. The average annual temperature is about 46 degrees F. The frost-free season at 32 degrees F is 105 to 145 days. The growing season at 28 degrees F is 165 to 185 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Bjork: Promising
- Cle Elum: Promising
- Peoh: Promising
- Cowiche: Possible
- Morical: Possible
- Dragoon: Possible
- Georgecreek: Possible
- Kingmont: Possible
See it on the map
Open a Billyridge spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 75%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Billyridge gravelly sandy loam, 0 to 8 percent slopes, map unit 37 in Cashmere Mountain Area, Washington, Parts of Chelan and Okanogan Counties.
- Official Series Description: Billyridge(revised 10/2002), established.
- Taxonomic class: Coarse-loamy, mixed, superactive, mesic Ultic Haploxerolls
- Rated with rule version 2026-09-28.1; the method is on the About page.