Cle Elum soil
Wild-clay potential
Promising
Promising: a loamy layer with some clay typically about 14 to 36 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Cle Elum soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Cle Elum spot on the map
Rated from the USDA soil survey record for Cle Elum loam, 30 to 60 percent south slopes (Cashmere Mountain Area, Washington, Parts of Chelan and Okanogan Counties) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Raises the potential Clay-enriched layer: about 30% clay in the fine-earth portion.
- Note Moderate engineering plasticity index (17.5).
- Raises the potential The official series description calls the wet soil moderately sticky and moderately plastic (a field observation, not a ceramic test).
- Note Thick enough to investigate (about 22 in (55 cm)).
- Note Typically starts within about 14 in (36 cm) of the surface.
- Note Few rock fragments (about 6% by volume).
Layer by layer
- Sandy layerH1 A loam layer about 0 to 14 in down: about 15% clay, low plasticity when wet, pale brown when moist. Weak indication
- Loamy layerH2best layer A clay loam layer about 14 to 36 in down: about 30% clay, moderate plasticity when wet, pale brown when moist. Promising
- BedrockH3 Weathered bedrock about 36 to 46 in down: no clay layer to dig. Weak indication
What it looks like raw
The loamy layer (H2), 14 to 36 in down in the typical profile: pale brown (10YR 6/3), dark yellowish brown (10YR 4/4) moist; hard, very firm, sticky and plastic. Raw colour is not fired colour.
About the soil
- Parent material: residuum and colluvium from sandstone mixed with minor amounts of loess and volcanic ash.
- USDA family mineralogy: mixed.
- USDA family particle-size class: fine-loamy.
- Drainage: well drained.
- Paralithic bedrock typically about 36 in (91 cm) down.
Where it is mapped
Seen on the map as the most common soil in 1 map unit in Washington, in these survey areas: Cashmere Mountain Area, Washington, Parts of Chelan and Okanogan Counties.
By state: wild clay in Washington.
USDA, distribution and extent: Eastern slopes of Cascade Mountains in central Washington. Cle Elum series is of moderate extent.
USDA, geographic setting: Cle Elum soils are on foothills and mountain backslopes and have slopes of 25 to 75 percent. The soils formed in residuum and colluvium from sandstone and a minor amount of loess and volcanic ash in the upper part. Elevation is 1,000 to 3,800 feet. These soils are in a continental climate of warm, dry summers and cool, moist winters. The average annual precipitation is 18 to 35 inches. The mean January temperature is about 26 degrees F, mean July temperature is about 67 degrees F, and the average annual temperature is 45 to 47 degrees F. The growing season at 28 degrees F is 190 to 220 days and the forst-free season is 150 to 185 days..
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Bjork: Promising
- Cowiche: Possible
- Dragoon: Possible
- Georgecreek: Possible
- Kingmont: Possible
- Loneridge: Possible
- Morical: Possible
- Nahahum: Possible
See it on the map
Open a Cle Elum spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 75%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
- Parts of the Official Series Description could not be interpreted; open the original for the complete text.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Cle Elum loam, 30 to 60 percent south slopes, map unit 80 in Cashmere Mountain Area, Washington, Parts of Chelan and Okanogan Counties.
- Official Series Description: Cle Elum(revised 10/2002), established.
- Taxonomic class: Fine-loamy, mixed, superactive, mesic Ultic Haploxeralfs
- Rated with rule version 2026-09-28.1; the method is on the About page.