Loneridge soil
Wild-clay potential
Possible
Possible: a clayey layer typically about 9 to 36 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Loneridge soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Loneridge spot on the map
Rated from the USDA soil survey record for Loneridge stony loam, 3 to 30 percent slopes (Cashmere Mountain Area, Washington, Parts of Chelan and Okanogan Counties) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Raises the potential Clayey layer: about 45% clay in the fine-earth portion.
- Raises the potential High engineering plasticity index (25): USDA's estimate suggests plastic behavior when wet.
- Raises the potential The official series description calls the wet soil moderately sticky and moderately plastic (a field observation, not a ceramic test).
- Note Thick enough to investigate (about 27 in (68 cm)).
- Note Typically starts within about 9 in (23 cm) of the surface.
- Lowers the potential High rock content (about 48% by volume) lowers its practical promise; the clay percentage applies only to the fine earth between the rocks.
- Note High shrink-swell (linear extensibility about 7.5%): often very plastic, and prone to cracking as it dries.
Layer by layer
- Loamy layerH1 A stony ashy loam layer about 0 to 9 in down: about 20% clay, moderate plasticity when wet, brown when moist. Weak indication
- Clay-rich layerH2best layer A very cobbly clay loam layer about 9 to 36 in down: about 45% clay, high plasticity when wet, light yellowish brown when moist. Possible
- Loamy layerH3 An extremely gravelly clay loam layer about 36 to 60 in down: about 33% clay, moderate plasticity when wet, pale brown when moist. Weak indication
What it looks like raw
The clay-rich layer (H2), 9 to 36 in down in the typical profile: light yellowish brown (10YR 6/4) dry, dark yellowish brown (10YR 4/4) moist; hard, very firm, moderately sticky and moderately plastic. Raw colour is not fired colour.
About the soil
- Parent material: residuum and colluvium from basalt or andesite mixed with loess and volcanic ash.
- USDA family mineralogy: smectitic. Smectite-rich clays are usually very plastic and shrink a lot as they dry.
- USDA family particle-size class: clayey-skeletal.
- Drainage: well drained.
Where it is mapped
Seen on the map as the most common soil in 2 map units in Washington, in these survey areas: Cashmere Mountain Area, Washington, Parts of Chelan and Okanogan Counties.
By state: wild clay in Washington.
USDA, distribution and extent: Central Washington and northeastern Oregon; MLRA 6; moderate extent
USDA, geographic setting: Elevation--730 to 1650 m
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Bjork: Promising
- Cle Elum: Promising
- Cowiche: Possible
- Dragoon: Possible
- Georgecreek: Possible
- Kingmont: Possible
- Morical: Possible
- Nahahum: Possible
See it on the map
Open a Loneridge spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 85%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
- Parts of the Official Series Description could not be interpreted; open the original for the complete text.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Loneridge stony loam, 3 to 30 percent slopes, map unit 167 in Cashmere Mountain Area, Washington, Parts of Chelan and Okanogan Counties.
- Official Series Description: Loneridge(revised 09/2019), established.
- Taxonomic class: Clayey-skeletal, smectitic, frigid Vertic Palexeralfs
- Rated with rule version 2026-09-28.1; the method is on the About page.