Cowiche soil
Wild-clay potential
Possible
Possible: a loamy layer with some clay typically about 22 to 36 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Cowiche soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Cowiche spot on the map
Rated from the USDA soil survey record for Cowiche silt loam, 45 to 65 percent slopes (Chelan County Area, Washington (Parts of Chelan and Kittitas Counties)) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Note Loamy layer with some clay: about 24% clay. It may need settling or refining to become a clay body.
- Note Moderate engineering plasticity index (12.5).
- Raises the potential The official series description calls the wet soil moderately sticky and moderately plastic (a field observation, not a ceramic test).
- Note Thick enough to investigate (about 14 in (35 cm)).
- Note Typically starts within about 22 in (56 cm) of the surface.
- Note Few rock fragments (about 6% by volume).
Layer by layer
- Sandy layerH1 A silt loam layer about 0 to 8 in down: about 15% clay, low plasticity when wet, brown when moist. Weak indication
- Sandy layerH2 A silt loam layer about 8 to 22 in down: about 15% clay, low plasticity when wet, brown when moist. Weak indication
- Loamy layerH3best layer A silt loam layer about 22 to 36 in down: about 24% clay, moderate plasticity when wet, yellowish brown when moist. Possible
- Loamy layerH4 A sandy clay loam layer about 36 to 50 in down: about 24% clay, moderate plasticity when wet, pale brown when moist. Weak indication
- Sandy layerH5 A sandy loam layer about 50 to 60 in down: about 12% clay, low plasticity when wet, brown when moist. Weak indication
What it looks like raw
The loamy layer (H3), 22 to 36 in down in the typical profile: yellowish brown (10YR 5/4), dark yellowish brown (10YR 3/4) moist; hard, firm, sticky and plastic. Raw colour is not fired colour.
About the soil
- Parent material: residuum weathered from metamorphic and sedimentary rock with loess.
- USDA family mineralogy: mixed.
- USDA family particle-size class: fine-loamy.
- Drainage: well drained.
Where it is mapped
Seen on the map as the most common soil in 2 map units in Washington, in these survey areas: Cashmere Mountain Area, Washington, Parts of Chelan and Okanogan Counties; Chelan County Area, Washington (Parts of Chelan and Kittitas Counties).
By state: wild clay in Washington.
USDA, distribution and extent: Central Washington. Series is of moderate extent.
USDA, geographic setting: The Cowiche soils are at elevations of 1,000 to 4,800 feet on mountains and foothills. Slopes are 0 to 70 percent. These soils formed in loess over residuum from sandstone, or schist. The climate is semiarid with an average annual precipitation of 9 to 12 inches. These soils have hot, dry summers and cold, moist winters; average annual temperature is 49 degrees F., average January temperature is 29 degrees F., average July temperature is 70 degrees F., and average frost-free season is 135 to 185 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Bjork: Promising
- Cle Elum: Promising
- Peoh: Promising
- Morical: Possible
- Dragoon: Possible
- Georgecreek: Possible
- Kingmont: Possible
- Loneridge: Possible
See it on the map
Open a Cowiche spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 100%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Cowiche silt loam, 45 to 65 percent slopes, map unit CwF in Chelan County Area, Washington (Parts of Chelan and Kittitas Counties).
- Official Series Description: Cowiche(revised 12/1999), established.
- Taxonomic class: Fine-loamy, mixed, superactive, mesic Aridic Argixerolls
- Rated with rule version 2026-09-28.1; the method is on the About page.