Anatone soil
Wild-clay potential
Weak indication
Weak indication: no layer of Anatone shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Anatone soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Anatone spot on the map
Rated from the USDA soil survey record for Anatone-Rock outcrop complex, 30 to 60 percent slopes (Cashmere Mountain Area, Washington, Parts of Chelan and Okanogan Counties) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Note Loamy layer with some clay: about 20% clay. It may need settling or refining to become a clay body.
- Lowers the potential Low engineering plasticity index (5): little plastic behavior expected when wet.
- Note The official series description calls the wet soil slightly sticky and slightly plastic.
- Note Moderate thickness (about 7 in (18 cm)).
- Note Typically starts within about 4 in (10 cm) of the surface.
- Lowers the potential High rock content (about 51% by volume) lowers its practical promise; the clay percentage applies only to the fine earth between the rocks.
Layer by layer
- Sandy layerH1 A cobbly loam layer about 0 to 4 in down: about 15% clay, low plasticity when wet, reddish brown when moist. Weak indication
- Loamy layerH2best layer A very gravelly loam layer about 4 to 11 in down: about 20% clay, low plasticity when wet, reddish brown when moist. Weak indication
- BedrockH3 Unweathered bedrock about 11 to 15 in down: no clay layer to dig. Weak indication
What it looks like raw
The loamy layer (H2), 4 to 11 in down in the typical profile: reddish brown (5YR 4/4), dark reddish brown (5YR 3/3) moist; hard, friable, slightly sticky and slightly plastic. Raw colour is not fired colour.
About the soil
- Parent material: volcanic ash and loess mixed with colluvium and residuum from basalt and andesite.
- USDA family mineralogy: mixed.
- USDA family particle-size class: loamy-skeletal.
- Drainage: well drained.
- Lithic bedrock typically about 11 in (28 cm) down.
Where it is mapped
Seen on the map as the most common soil in 2 map units in Washington, in these survey areas: Cashmere Mountain Area, Washington, Parts of Chelan and Okanogan Counties; Chelan County Area, Washington (Parts of Chelan and Kittitas Counties).
By state: wild clay in Washington.
USDA, distribution and extent: Washington, Oregon, and Idaho; MLRA 9. The series is of large extent.
USDA, geographic setting: Anatone soils are on plateaus, hills, ridgetops, canyons, structural benches, and south or west-facing mountain back slopes. Elevations are 2,520 to 6,200 feet (768 to 1890 meters). In northeastern Oregon, areas of Anatone soils are recognized on north-facing slopes at elevations down to 2,000 feet (526 meters). Slopes are 0 to 90 percent. These soils formed in loess and ash mixed with residuum and colluvium from basalt, andesite or welded tuff. Anatone soils are in a continental climate with warm, dry summers and cold, wet winters. The mean annual precipitation is 14 to 35 inches (356 to 889 mm). The mean annual temperature is 40 to 46 degrees F. The frost-free season is 50 to 130 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Bjork: Promising
- Cle Elum: Promising
- Peoh: Promising
- Cowiche: Possible
- Morical: Possible
- Dragoon: Possible
- Georgecreek: Possible
- Kingmont: Possible
See it on the map
Open a Anatone spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 70%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
- Parts of the Official Series Description could not be interpreted; open the original for the complete text.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Anatone-Rock outcrop complex, 30 to 60 percent slopes, map unit 17 in Cashmere Mountain Area, Washington, Parts of Chelan and Okanogan Counties.
- Official Series Description: Anatone(revised 09/2013), established.
- Taxonomic class: Loamy-skeletal, mixed, superactive, frigid Lithic Haploxerolls
- Rated with rule version 2026-09-28.1; the method is on the About page.