Pogue soil
Wild-clay potential
Weak indication
Weak indication: no layer of Pogue shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Pogue soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Rated from the USDA soil survey record for Pogue fine sandy loam, 3 to 8 percent slopes (Chelan County Area, Washington (Parts of Chelan and Kittitas Counties)) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Lowers the potential Too little clay to be a clay body on its own: about 3% clay.
- Lowers the potential Low engineering plasticity index (2.5): little plastic behavior expected when wet.
- Note Thick enough to investigate (about 30 in (76 cm)).
- Note Typically starts about 30 in (76 cm) down; expect real digging or look for cuts and banks.
- Lowers the potential High rock content (about 41% by volume) lowers its practical promise; the clay percentage applies only to the fine earth between the rocks.
Layer by layer
- Sandy layerH1 A fine sandy loam layer about 0 to 17 in down: about 8% clay, low plasticity when wet, yellowish brown when moist. Weak indication
- Sandy layerH2 A very gravelly fine sandy loam layer about 17 to 30 in down: about 8% clay, low plasticity when wet, yellowish brown when moist. Weak indication
- Sandy layerH3best layer An extremely gravelly coarse sand layer about 30 to 60 in down: about 3% clay, low plasticity when wet. Weak indication
What it looks like raw
The sandy layer (H3), 30 to 60 in down in the typical profile: loose. Raw colour is not fired colour.
About the soil
- Parent material: glacial outwash.
- USDA family mineralogy: mixed.
- USDA family particle-size class: coarse-loamy over sandy or sandy-skeletal.
- Drainage: somewhat excessively drained.
Where it is mapped
Seen on the map as the most common soil in 8 map units in Washington, in these survey areas: Chelan County Area, Washington (Parts of Chelan and Kittitas Counties); Douglas County, Washington.
By state: wild clay in Washington.
USDA, distribution and extent: North central Washington. This series is of moderate extent.
USDA, geographic setting: Pogue soils are on glacial outwash terraces and terrace escarpments at elevations of 600 to 2,200 feet. Slopes are 0 to 65 percent. The soils formed in loess and glacial outwash. Average annual precipitation is 8 to 12 inches. These soils occur in a climate of hot, dry summers and cold, moist winters. The average January temperature is 24 degrees F.; the average July temperature is 75 degrees F.; and the mean annual temperature is 47 to 51 degrees F. The frost free season is 140 to 190 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Bjork: Promising
- Peoh: Promising
- Cowiche: Possible
- Morical: Possible
- Zen: Possible
- Cashmont: Weak indication
- Entiat: Weak indication
- Quincy: Weak indication
See it on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 100%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
- Parts of the Official Series Description could not be interpreted; open the original for the complete text.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Pogue fine sandy loam, 3 to 8 percent slopes, map unit PoB in Chelan County Area, Washington (Parts of Chelan and Kittitas Counties).
- Official Series Description: Pogue(revised 05/2006), established.
- Taxonomic class: Coarse-loamy over sandy or sandy-skeletal, mixed, superactive, mesic Aridic Haploxerolls
- Rated with rule version 2026-09-28.1; the method is on the About page.