Pequea soil
Wild-clay potential
Weak indication
Weak indication: no layer of Pequea shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Pequea soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Rated from the USDA soil survey record for Pequea silt loam, 8 to 15 percent slopes (Lancaster County, Pennsylvania) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Lowers the potential Too little clay to be a clay body on its own: about 15% clay.
- Lowers the potential Low engineering plasticity index (5): little plastic behavior expected when wet.
- Note Thick enough to investigate (about 26 in (66 cm)).
- Note Typically starts about 26 in (66 cm) down; expect real digging or look for cuts and banks.
- Lowers the potential Noticeable rock fragments (about 25% by volume); screening would be needed and the clay percentage applies to the fine earth only.
Layer by layer
- TopsoilAp A silt loam layer about 0 to 10 in down: about 15% clay, low plasticity when wet, dark brown when moist. Weak indication
- Sandy layerB A channery loam layer about 10 to 26 in down: about 15% clay, low plasticity when wet, very dark grayish brown when moist. Weak indication
- Sandy layerCbest layer A channery loam layer about 26 to 52 in down: about 15% clay, low plasticity when wet, dark olive gray when moist. Weak indication
- BedrockR Bedrock about 52 to 56 in down: no clay layer to dig. Weak indication
What it looks like raw
The sandy layer (C), 26 to 52 in down in the typical profile: dark olive gray (5Y 3/2), and olive gray (5Y 4/2); channery loam; friable. Raw colour is not fired colour.
About the soil
- Parent material: residuum weathered from limestone.
- USDA family mineralogy: mixed.
- USDA family particle-size class: coarse-loamy.
- Drainage: well drained.
- Lithic bedrock typically about 52 in (132 cm) down.
Where it is mapped
Seen on the map as the most common soil in 3 map units in Pennsylvania, in these survey areas: Lancaster County, Pennsylvania.
By state: wild clay in Pennsylvania.
USDA, distribution and extent: Southeastern Pennsylvania and Central Maryland. The series is of moderate extent.
USDA, geographic setting: Pequea soils are on gently sloping to very steep hillsides and ridges. Slope gradients are between 3 and 50 percent. The soils are formed in residuum weathered from interbedded micaceous limestone, graphitic phyllite, and schist. The climate is humid and temperate with mean annual precipitation of 40 to 44 inches; average annual temperature is 50 degrees to 55 degrees F and the growing season is 170 to 200 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Hagerstown: Strong lead
- Watchung: Strong lead
- Baile: Promising
- Bowmansville: Promising
- Bucks: Promising
- Chester: Promising
- Conestoga: Promising
- Duffield: Promising
See it on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 90%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Pequea silt loam, 8 to 15 percent slopes, map unit PeC in Lancaster County, Pennsylvania.
- Official Series Description: Pequea(revised 01/2006), established.
- Taxonomic class: Coarse-loamy, mixed, active, mesic Typic Eutrudepts
- Rated with rule version 2026-09-28.1; the method is on the About page.