Nims soil
Wild-clay potential
Weak indication
Weak indication: no layer of Nims shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Nims soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Rated from the USDA soil survey record for Nims silt loam, 3 to 8 percent slopes (Asotin County Area, Washington (Asotin and Garfield Counties)) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Note Loamy layer with some clay: about 22% clay. It may need settling or refining to become a clay body.
- Note Moderate engineering plasticity index (12.5).
- Raises the potential The official series description calls the wet soil moderately sticky and moderately plastic (a field observation, not a ceramic test).
- Note Moderate thickness (about 9 in (22 cm)).
- Note Typically starts within about 14 in (36 cm) of the surface.
- Lowers the potential High rock content (about 35% by volume) lowers its practical promise; the clay percentage applies only to the fine earth between the rocks.
- Note USDA reports about 20% calcium carbonate; lime in a clay body deserves testing.
Layer by layer
- Sandy layerH1 A silt loam layer about 0 to 7 in down: about 13% clay, low plasticity when wet, dark grayish brown when moist. Weak indication
- Loamy layerH2 A silt loam layer about 7 to 14 in down: about 23% clay, moderate plasticity when wet, dark grayish brown when moist. Weak indication
- Loamy layerH3best layer A very cobbly loam layer about 14 to 23 in down: about 22% clay, moderate plasticity when wet, brown when moist. Weak indication
- BedrockH4 Unweathered bedrock about 23 to 27 in down: no clay layer to dig. Weak indication
What it looks like raw
The loamy layer (H3), 14 to 23 in down in the typical profile: brown (10YR 5/3), dark brown (10YR 3/3) moist; slightly hard, friable, sticky and plastic. Raw colour is not fired colour.
About the soil
- Parent material: loess and slope alluvium derived from weathered basalt.
- USDA family mineralogy: mixed.
- USDA family particle-size class: fine-loamy.
- Drainage: well drained.
- Lithic bedrock typically about 23 in (58 cm) down.
Where it is mapped
Seen on the map as the most common soil in 5 map units in Washington, in these survey areas: Asotin County Area, Washington (Asotin and Garfield Counties).
By state: wild clay in Washington.
USDA, distribution and extent: ; Southeastern Washington. The series in of small extent.
USDA, geographic setting: Nims soils are on basalt plateaus. Slopes are 3 to 30 percent. These soils formed in loess and slope alluvium from weathered basalt. Elevations range from 1,200 to 2,700 feet. Summers are warm and dry and winters are cool and moist. The average annual precipitation ranges from 12 to 15 inches. Mean annual air temperature is about 51 degrees F. Frost-free season is 135 to 155 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Cloverland: Strong lead
- Weissenfels: Promising
- Alpowa: Weak indication
- Asotin: Weak indication
- Bolicker: Weak indication
- Bridgewater: Weak indication
- Chard: Weak indication
- Dallesport: Weak indication
See it on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 100%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
- Parts of the Official Series Description could not be interpreted; open the original for the complete text.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Nims silt loam, 3 to 8 percent slopes, map unit 76 in Asotin County Area, Washington (Asotin and Garfield Counties).
- Official Series Description: Nims(revised 10/2002), established.
- Taxonomic class: Fine-loamy, mixed, superactive, mesic Calcic Haploxerolls
- Rated with rule version 2026-09-28.1; the method is on the About page.