Chard soil
Wild-clay potential
Weak indication
Weak indication: no layer of Chard shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Chard soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Rated from the USDA soil survey record for Chard silt loam, 3 to 7 percent slopes (Whitman County, Washington) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Lowers the potential Too little clay to be a clay body on its own: about 6% clay.
- Lowers the potential Low engineering plasticity index (2.5): little plastic behavior expected when wet.
- Note Thick enough to investigate (about 28 in (71 cm)).
- Note Typically starts about 32 in (81 cm) down; expect real digging or look for cuts and banks.
- Note Few rock fragments (about 6% by volume).
- Note USDA reports about 23% calcium carbonate; lime in a clay body deserves testing.
Layer by layer
- Sandy layerH1 A silt loam layer about 0 to 17 in down: about 10% clay, low plasticity when wet, grayish brown when moist. Weak indication
- Sandy layerH2 A silt loam layer about 17 to 32 in down: about 10% clay, low plasticity when wet, brown when moist. Weak indication
- Sandy layerH3best layer A sandy loam layer about 32 to 60 in down: about 6% clay, low plasticity when wet, grayish brown when moist. Weak indication
What it looks like raw
The sandy layer (H3), 32 to 60 in down in the typical profile: grayish brown (10YR 5/2); loose. Raw colour is not fired colour.
About the soil
- Parent material: volcanic ash and/or loess over glacial outwash.
- USDA family mineralogy: mixed.
- USDA family particle-size class: coarse-loamy.
- Drainage: well drained.
Where it is mapped
Seen on the map as the most common soil in 16 map units in Idaho, Washington, in these survey areas: Asotin County Area, Washington (Asotin and Garfield Counties); Garfield County Area, Washington; Lewis and Nez Perce Counties, Idaho; Whitman County, Washington.
By state: wild clay in Idaho,wild clay in Washington.
USDA, distribution and extent: Southeastern Washington, northwestern Idaho, and northeastern Oregon; MLRA 9. Series is of moderate extent.
USDA, geographic setting: Chard soils are on lacustrine or outwash terraces and terrace escarpments at elevations of 600 to 2,000 feet. Slopes are 0 to 65 percent. These soils formed from a mixture of loess and glaciofluvial or lacustrine material. The summers are hot and dry and the winters are cool and moist. Average annual precipitation is 12 to 16 inches. Mean annual temperature is 47 to 53 degrees F. The frost- free season is 135 to 190 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Cloverland: Strong lead
- Cramont: Strong lead
- Garfield: Strong lead
- Konert: Strong lead
- Latah: Strong lead
- Taney: Strong lead
- Tilma: Strong lead
- Caldwell: Promising
See it on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 100%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Chard silt loam, 3 to 7 percent slopes, map unit 26 in Whitman County, Washington.
- Official Series Description: Chard(revised 05/2006), established.
- Taxonomic class: Coarse-loamy, mixed, superactive, mesic Calcic Haploxerolls
- Rated with rule version 2026-09-28.1; the method is on the About page.