Tilma soil
Wild-clay potential
Strong lead
Strong lead: a clayey layer typically about 21 to 60 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Tilma soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Rated from the USDA soil survey record for Tilma silt loam, 7 to 25 percent slopes (Whitman County, Washington) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Raises the potential Clayey layer: about 43% clay in the fine-earth portion.
- Raises the potential High engineering plasticity index (27.5): USDA's estimate suggests plastic behavior when wet.
- Note The official series description calls the wet soil slightly sticky and slightly plastic.
- Note Thick enough to investigate (about 39 in (99 cm)).
- Note Typically starts within about 21 in (53 cm) of the surface.
- Missing data Rock fragment content is not reported.
- Note High shrink-swell (linear extensibility about 7.5%): often very plastic, and prone to cracking as it dries.
- Note Engineering class CH: a clay of high plasticity in the Unified system.
Layer by layer
- Loamy layerH1 A silt loam layer about 0 to 21 in down: about 23% clay, low plasticity when wet, dark grayish brown when moist. Weak indication
- Clay-rich layerH2best layer A silty clay layer about 21 to 60 in down: about 43% clay, high plasticity when wet, light yellowish brown when moist. Strong lead
What it looks like raw
The clay-rich layer (H2), 21 to 60 in down in the typical profile: light yellowish brown (10YR 6/4), very pale brown (10YR 7/3) rubbed, yellowish brown (10YR 5/4) moist, brown (7.5YR 5/3) rubbed; extremely hard, extremely firm, slightly sticky and slightly plastic. Raw colour is not fired colour.
About the soil
- Parent material: loess with some ash.
- USDA family mineralogy: mixed.
- USDA family particle-size class: fine.
- Drainage: moderately well drained.
Where it is mapped
Seen on the map as the most common soil in 5 map units in Idaho, Washington, in these survey areas: Latah County, Idaho; Whitman County, Washington.
By state: wild clay in Idaho,wild clay in Washington.
USDA, distribution and extent: Loess hills and plains region in the prairies in northern Idaho and eastern Washington. MLRA 9. Moderately extensive.
USDA, geographic setting: These soils are on plains and hills on plateaus, mainly near drainageways. Slopes range from about 3 to 25 percent. Elevations are 2,300 to 3,200 feet. The soils formed in older loess, probably mostly of the recent or Pinedale surface, Early Bull Lake or Pre Bull Lake. The mean annual precipitation is 18 to 25 inches. The frost-free period is 110 to 160 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Garfield: Strong lead
- Latah: Strong lead
- Driscoll: Strong lead
- Konert: Strong lead
- Naff: Promising
- Thatuna: Promising
- Caldwell: Promising
- Latahco: Promising
See it on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 100%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Tilma silt loam, 7 to 25 percent slopes, map unit 111 in Whitman County, Washington.
- Official Series Description: Tilma(revised 09/2013), established.
- Taxonomic class: Fine, mixed, superactive, mesic Xeric Argialbolls
- Rated with rule version 2026-09-28.1; the method is on the About page.