Thatuna soil
Wild-clay potential
Promising
Promising: a loamy layer with some clay typically about 42 to 60 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Thatuna soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Thatuna spot on the map
Rated from the USDA soil survey record for Thatuna silt loam, 3 to 7 percent slopes (Whitman County, Washington) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Raises the potential Clay-enriched layer: about 30% clay in the fine-earth portion.
- Note Moderate engineering plasticity index (17.5).
- Raises the potential The official series description calls the wet soil moderately sticky and moderately plastic (a field observation, not a ceramic test).
- Note Thick enough to investigate (about 18 in (45 cm)).
- Note Typically starts about 42 in (107 cm) down; expect real digging or look for cuts and banks.
- Missing data Rock fragment content is not reported.
Layer by layer
- Sandy layerH1 A silt loam layer about 0 to 42 in down: about 15% clay, low plasticity when wet, very pale brown when moist. Weak indication
- Loamy layerH2best layer A silty clay loam layer about 42 to 60 in down: about 30% clay, moderate plasticity when wet, light yellowish brown when moist. Promising
What it looks like raw
The loamy layer (H2), 42 to 60 in down in the typical profile: light yellowish brown (10YR 6/4) dry, brown (7.5YR 4/3) moist; very hard, very firm, moderately sticky and moderately plastic. Raw colour is not fired colour.
About the soil
- Parent material: loess and ash.
- USDA family mineralogy: mixed.
- USDA family particle-size class: fine-silty.
- Drainage: moderately well drained.
Where it is mapped
Seen on the map as the most common soil in 12 map units in Idaho, Washington, in these survey areas: Latah County, Idaho; Lewis and Nez Perce Counties, Idaho; Whitman County, Washington.
By state: wild clay in Idaho,wild clay in Washington.
USDA, distribution and extent: Loess region in prairies of northern Idaho, eastern Washington, and northeastern Oregon; MLRA 9; moderate extent
USDA, geographic setting: Elevation--550 to 975 m
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Garfield: Strong lead
- Latah: Strong lead
- Tilma: Strong lead
- Cramont: Strong lead
- Driscoll: Strong lead
- Konert: Strong lead
- Taney: Strong lead
- Naff: Promising
See it on the map
Open a Thatuna spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 100%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Thatuna silt loam, 3 to 7 percent slopes, map unit 103 in Whitman County, Washington.
- Official Series Description: Thatuna(revised 06/2016), established.
- Taxonomic class: Fine-silty, mixed, superactive, mesic Oxyaquic Argixerolls
- Rated with rule version 2026-09-28.1; the method is on the About page.