Taney soil
Wild-clay potential
Strong lead
Strong lead: a clay-enriched layer typically about 36 to 63 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Taney soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Rated from the USDA soil survey record for Taney-Joel complex, 10 to 20 percent slopes (Lewis and Nez Perce Counties, Idaho) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Raises the potential Clayey layer: about 45% clay in the fine-earth portion.
- Note USDA labels this a "Btb" horizon: a subsoil layer where clay has accumulated.
- Raises the potential High engineering plasticity index (32): USDA's estimate suggests plastic behavior when wet.
- Raises the potential The official series description calls the wet soil moderately sticky and moderately plastic (a field observation, not a ceramic test).
- Note Thick enough to investigate (about 27 in (69 cm)).
- Note Typically starts about 36 in (91 cm) down; expect real digging or look for cuts and banks.
- Missing data Rock fragment content is not reported.
- Note Engineering class CH: a clay of high plasticity in the Unified system.
Layer by layer
- TopsoilA An ashy silt loam layer about 0 to 14 in down: about 24% clay, low plasticity when wet, very dark gray when moist. Weak indication
- Loamy layerBw A silt loam layer about 14 to 23 in down: about 23% clay, moderate plasticity when wet, dark brown when moist. Possible
- Sandy layerE A silt loam layer about 23 to 29 in down: about 15% clay, moderate plasticity when wet, dark brown when moist. Weak indication
- Clay subsoilBtxb A silty clay loam layer about 29 to 36 in down: about 29% clay, high plasticity when wet, yellowish brown when moist. Promising
- Clay subsoilBtbbest layer A silty clay layer about 36 to 63 in down: about 45% clay, high plasticity when wet, yellowish brown when moist. Strong lead
What it looks like raw
The clay subsoil (Btb), 36 to 63 in down in the typical profile: yellowish brown (10YR 5/4), light yellowish brown (10YR 6/4) dry; very hard, extremely firm and brittle, moderately sticky and moderately plastic. Raw colour is not fired colour.
About the soil
- Parent material: volcanic ash over loess.
- USDA family mineralogy: mixed.
- USDA family particle-size class: fine-silty.
- Drainage: moderately well drained.
Where it is mapped
Seen on the map as the most common soil in 1 map unit in Idaho, in these survey areas: Lewis and Nez Perce Counties, Idaho.
By state: wild clay in Idaho.
USDA, distribution and extent: Northern Idaho; MLRA 9 and 43A. The series is of large extent; about 156,000 acres.
USDA, geographic setting: The Taney soils are on dissected hills and hills on basalt plains, plateaus, and structural benches. The soils formed in deep loess or reworked loess with an influence of volcanic ash in the upper part. Elevation is typically 700 to 1220 meters but may range down to (366 meters) on north-facing slopes. Slopes are 0 to 35 percent. The average annual precipitation is 610 to 940 millimeters, including 1.2 to 1.5 meters of snow. The average annual temperature is 4.4 to 7.7 degrees C. The frost-free period is 80 to 130 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Cramont: Strong lead
- Caldwell: Promising
- Latahco: Promising
- Naff: Promising
- Slickpoo: Promising
- Thatuna: Promising
- Almota: Possible
- Athena: Possible
See it on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 50%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
- Parts of the Official Series Description could not be interpreted; open the original for the complete text.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Taney-Joel complex, 10 to 20 percent slopes, map unit 129 in Lewis and Nez Perce Counties, Idaho.
- Official Series Description: Taney(revised 09/2013), established.
- Taxonomic class: Fine-silty, mixed, superactive, frigid Vitrandic Argixerolls
- Rated with rule version 2026-09-28.1; the method is on the About page.