Almota soil
Wild-clay potential
Possible
Possible: a loamy layer with some clay typically about 9 to 29 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Almota soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Rated from the USDA soil survey record for Almota silt loam, 7 to 25 percent slopes (Whitman County, Washington) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Note Loamy layer with some clay: about 22% clay. It may need settling or refining to become a clay body.
- Note Moderate engineering plasticity index (10).
- Note The official series description calls the wet soil slightly sticky and slightly plastic.
- Note Thick enough to investigate (about 20 in (51 cm)).
- Note Typically starts within about 9 in (23 cm) of the surface.
- Note Few rock fragments (about 10% by volume).
- Note USDA reports about 25% calcium carbonate; lime in a clay body deserves testing.
Layer by layer
- Sandy layerH1 A silt loam layer about 0 to 9 in down: about 18% clay, low plasticity when wet, dark grayish brown when moist. Weak indication
- Loamy layerH2best layer A silt loam layer about 9 to 29 in down: about 22% clay, moderate plasticity when wet, pale brown when moist. Possible
- Loamy layerH3 A gravelly silt loam layer about 29 to 35 in down: about 22% clay, moderate plasticity when wet, white when moist. Weak indication
- BedrockH4 Unweathered bedrock about 35 to 39 in down: no clay layer to dig. Weak indication
What it looks like raw
The loamy layer (H2), 9 to 29 in down in the typical profile: pale brown (10YR 6/3), brown (10YR 4/3) moist; slightly hard, friable, slightly sticky and slightly plastic. Raw colour is not fired colour.
About the soil
- USDA family mineralogy: mixed.
- USDA family particle-size class: fine-loamy.
- Drainage: well drained.
- Lithic bedrock typically about 35 in (89 cm) down.
Where it is mapped
Seen on the map as the most common soil in 3 map units in Idaho, Washington, in these survey areas: Lewis and Nez Perce Counties, Idaho; Whitman County, Washington.
By state: wild clay in Idaho,wild clay in Washington.
USDA, distribution and extent: Southeastern Washington, northcentral Idaho and possibly eastern Oregon. The soils are moderately extensive.
USDA, geographic setting: Almota soils are on sloping to very steep uplands at elevations of 1,500 to 2,700 feet. These soils formed in loess and colluvium from basalt. Summers are warm and dry, winters are cold and moist. Mean annual precipitation is 12 to 18 inches. Average January temperature is 28 degrees F., mean July temperature is 68 degrees F., average annual temperature is 49 degrees to 51 degrees F., with a frost-free season of 130 to 160 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Cramont: Strong lead
- Garfield: Strong lead
- Konert: Strong lead
- Latah: Strong lead
- Taney: Strong lead
- Tilma: Strong lead
- Caldwell: Promising
- Naff: Promising
See it on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 100%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
- Parts of the Official Series Description could not be interpreted; open the original for the complete text.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Almota silt loam, 7 to 25 percent slopes, map unit 1 in Whitman County, Washington.
- Official Series Description: Almota, established.
- Taxonomic class: Fine-loamy, mixed, superactive, mesic Calcic Haploxerolls
- Rated with rule version 2026-09-28.1; the method is on the About page.