Alpowa soil
Wild-clay potential
Weak indication
Weak indication: no layer of Alpowa shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Alpowa soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Rated from the USDA soil survey record for Alpowa cobbly silt loam, 30 to 65 percent slopes (Whitman County, Washington) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Lowers the potential Too little clay to be a clay body on its own: about 13% clay.
- Lowers the potential Low engineering plasticity index (2.5): little plastic behavior expected when wet.
- Note The official series description calls the wet soil slightly sticky and slightly plastic.
- Note Thick enough to investigate (about 36 in (92 cm)).
- Note Typically starts within about 8 in (20 cm) of the surface.
- Lowers the potential High rock content (about 42% by volume) lowers its practical promise; the clay percentage applies only to the fine earth between the rocks.
- Note USDA reports about 25% calcium carbonate; lime in a clay body deserves testing.
Layer by layer
- Sandy layerH1 A cobbly silt loam layer about 0 to 8 in down: about 13% clay, low plasticity when wet, grayish brown when moist. Weak indication
- Sandy layerH2best layer A very gravelly silt loam layer about 8 to 44 in down: about 13% clay, low plasticity when wet, pale brown when moist. Weak indication
- BedrockH3 Unweathered bedrock about 44 to 48 in down: no clay layer to dig. Weak indication
What it looks like raw
The sandy layer (H2), 8 to 44 in down in the typical profile: pale brown (10YR 6/3), dark brown (10YR 4/3) moist; slightly hard, friable, slightly sticky and slightly plastic. Raw colour is not fired colour.
About the soil
- USDA family mineralogy: mixed.
- USDA family particle-size class: loamy-skeletal.
- Drainage: well drained.
- Lithic bedrock typically about 44 in (112 cm) down.
Where it is mapped
Seen on the map as the most common soil in 4 map units in Idaho, Washington, in these survey areas: Asotin County Area, Washington (Asotin and Garfield Counties); Lewis and Nez Perce Counties, Idaho; Whitman County, Washington.
By state: wild clay in Idaho,wild clay in Washington.
USDA, distribution and extent: Southeastern Washington and southern Idaho. Series is moderately extensive.
USDA, geographic setting: Alpowa soils are on on lower canyon walls, hills and plateaus at elevations of 600 to 3,000 feet in Washington and northern Idaho, and alluvial fans at elevations of 4,300 to 5.800 feet in Idaho. Slopes are 1 to 75 percent. Alpowa soils formed in slope alluvium, colluvium, and alluvium from basalt and loess. Summers are warm and dry and winters are cool and moist. The average annual precipitation is 12 to 16 inches. The average July temperature is 69 to 72 degrees F. The average January temperature is 29 to 32 degrees F. The mean annual temperature is 48 to 52 degrees F. The frost-free season is 135 to 180 days in Washington and northern Idaho and 100 to 135 days in Idaho.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Cloverland: Strong lead
- Cramont: Strong lead
- Garfield: Strong lead
- Konert: Strong lead
- Latah: Strong lead
- Taney: Strong lead
- Tilma: Strong lead
- Caldwell: Promising
See it on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 100%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Alpowa cobbly silt loam, 30 to 65 percent slopes, map unit 3 in Whitman County, Washington.
- Official Series Description: Alpowa(revised 10/2002), established.
- Taxonomic class: Loamy-skeletal, mixed, superactive, mesic Calcic Haploxerolls
- Rated with rule version 2026-09-28.1; the method is on the About page.