Weissenfels soil
Wild-clay potential
Promising
Promising: a clayey layer typically about 7 to 12 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Weissenfels soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Weissenfels spot on the map
Rated from the USDA soil survey record for Weissenfels-Nims silt loams, 3 to 8 percent slopes (Asotin County Area, Washington (Asotin and Garfield Counties)) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Raises the potential Clayey layer: about 45% clay in the fine-earth portion.
- Raises the potential High engineering plasticity index (22.5): USDA's estimate suggests plastic behavior when wet.
- Raises the potential The official series description calls the wet soil very sticky and very plastic (a field observation, not a ceramic test).
- Lowers the potential Thin layer (about 5 in (12 cm)), hard to collect in quantity.
- Note Typically starts within about 7 in (18 cm) of the surface.
- Note Few rock fragments (about 9% by volume).
- Note Engineering class CH: a clay of high plasticity in the Unified system.
Layer by layer
- Loamy layerH1 A silt loam layer about 0 to 7 in down: about 20% clay, moderate plasticity when wet, dark grayish brown when moist. Possible
- Clay-rich layerH2best layer A silty clay layer about 7 to 12 in down: about 45% clay, high plasticity when wet, grayish brown when moist. Promising
- Clay-rich layerH3 A silty clay loam layer about 12 to 15 in down: about 38% clay, moderate plasticity when wet, brown when moist. Promising
- Loamy layerH4 A silt loam layer about 15 to 22 in down: about 24% clay, moderate plasticity when wet, brown when moist. Weak indication
- Loamy layerH5 A very gravelly loam layer about 22 to 37 in down: about 20% clay, moderate plasticity when wet, white when moist. Weak indication
- BedrockH6 Unweathered bedrock about 37 to 41 in down: no clay layer to dig. Weak indication
What it looks like raw
The clay-rich layer (H2), 7 to 12 in down in the typical profile: grayish brown (10YR 5/2), very dark grayish brown (10YR 3/2) moist, with common very dark brown (10YR 2/2); very hard, firm, very sticky and very plastic. Raw colour is not fired colour.
About the soil
- Parent material: loess and slope alluvium derived from weathered basalt.
- USDA family mineralogy: mixed.
- USDA family particle-size class: fine.
- Drainage: moderately well drained.
- Lithic bedrock typically about 37 in (94 cm) down.
Where it is mapped
Seen on the map as the most common soil in 1 map unit in Washington, in these survey areas: Asotin County Area, Washington (Asotin and Garfield Counties).
By state: wild clay in Washington.
USDA, distribution and extent: Southeastern Washington. The series is of small extent.
USDA, geographic setting: Weissenfels soils are on basalt plateaus. Slopes are 3 to 30 percent. These soils formed in loess and alluvium from weathered basalt. Elevation ranges from 1,200 to 2,700 feet. Summers are warm and dry and winters are cool and moist. The average annual precipitation ranges from 12 to 15 inches. Mean annual air temperature is about 51 degrees F. Frost-free season is 135 to 155 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Cloverland: Strong lead
- Alpowa: Weak indication
- Asotin: Weak indication
- Bolicker: Weak indication
- Bridgewater: Weak indication
- Chard: Weak indication
- Dallesport: Weak indication
- Ewall: Weak indication
See it on the map
Open a Weissenfels spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 45%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
- Parts of the Official Series Description could not be interpreted; open the original for the complete text.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Weissenfels-Nims silt loams, 3 to 8 percent slopes, map unit 115 in Asotin County Area, Washington (Asotin and Garfield Counties).
- Official Series Description: Weissenfels(revised 11/2002), established.
- Taxonomic class: Fine, mixed, superactive, mesic Duric Natrixerolls
- Rated with rule version 2026-09-28.1; the method is on the About page.