Asotin soil
Wild-clay potential
Weak indication
Weak indication: no layer of Asotin shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Asotin soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Rated from the USDA soil survey record for Asotin-Lickskillet-Rock outcrop complex, 40 to 90 percent slopes (Asotin County Area, Washington (Asotin and Garfield Counties)) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Lowers the potential Too little clay to be a clay body on its own: about 13% clay.
- Lowers the potential Low engineering plasticity index (2.5): little plastic behavior expected when wet.
- Lowers the potential The official series description calls the wet soil slightly sticky and nonplastic.
- Note Moderate thickness (about 11 in (28 cm)).
- Note Typically starts within about 0 in (0 cm) of the surface.
- Note Few rock fragments (about 3% by volume).
Layer by layer
- Sandy layerH1best layer A silt loam layer about 0 to 11 in down: about 13% clay, low plasticity when wet, dark grayish brown when moist. Weak indication
- Sandy layerH2 A silt loam layer about 11 to 19 in down: about 14% clay, low plasticity when wet, pale brown when moist. Weak indication
- Sandy layerH3 A gravelly silt loam layer about 19 to 23 in down: about 14% clay, low plasticity when wet, pale brown when moist. Weak indication
- BedrockH4 Unweathered bedrock about 23 to 27 in down: no clay layer to dig. Weak indication
What it looks like raw
The sandy layer (H1), 0 to 11 in down in the typical profile: dark grayish brown (10YR 4/2), very dark grayish brown (10YR 3/2) moist; slightly hard, very friable, slightly sticky and nonplastic. Raw colour is not fired colour.
About the soil
- Parent material: loess, colluvium and slope alluvium derived from weathered basalt.
- USDA family mineralogy: mixed.
- USDA family particle-size class: coarse-loamy.
- Drainage: well drained.
- Lithic bedrock typically about 23 in (58 cm) down.
Where it is mapped
Seen on the map as the most common soil in 1 map unit in Washington, in these survey areas: Asotin County Area, Washington (Asotin and Garfield Counties).
By state: wild clay in Washington.
USDA, distribution and extent: Southeastern Washington. This series is of moderate extent.
USDA, geographic setting: Asotin soils are on canyon side slopes and hillslopes at elevations of 800 to 2,600 feet. Slopes are 0 to 90 percent. Asotin soils formed in loess, and colluvium from basalt together with minor amounts of volcanic ash. Summers are warm and dry and winters are cool and moist. The mean annual precipitation is 12 to 16 inches. The mean January temperature is 30 to 34 degrees F. and the mean July temperature is 68 to 70 degrees F. The mean annual temperature is 48 to 54 degrees F. The frost-free season is 135 to 160 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Cloverland: Strong lead
- Weissenfels: Promising
- Alpowa: Weak indication
- Bolicker: Weak indication
- Bridgewater: Weak indication
- Chard: Weak indication
- Dallesport: Weak indication
- Ewall: Weak indication
See it on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 40%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
- Parts of the Official Series Description could not be interpreted; open the original for the complete text.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Asotin-Lickskillet-Rock outcrop complex, 40 to 90 percent slopes, map unit 3 in Asotin County Area, Washington (Asotin and Garfield Counties).
- Official Series Description: Asotin(revised 11/2008), established.
- Taxonomic class: Coarse-loamy, mixed, superactive, mesic Calcic Haploxerolls
- Rated with rule version 2026-09-28.1; the method is on the About page.