Newark soil
Wild-clay potential
Promising
Promising: a loamy layer with some clay typically about 16 to 32 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Newark soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Rated from the USDA soil survey record for Newark silt loam (Lancaster County, Pennsylvania) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Raises the potential Clay-enriched layer: about 28% clay in the fine-earth portion.
- Note Moderate engineering plasticity index (11.5).
- Note Thick enough to investigate (about 16 in (40 cm)).
- Note Typically starts within about 16 in (41 cm) of the surface.
- Note Few rock fragments (about 5% by volume).
Layer by layer
- Sandy layerH1 A silt loam layer about 0 to 16 in down: about 17% clay, low plasticity when wet, brown when moist. Weak indication
- Loamy layerH2best layer A silty clay loam layer about 16 to 32 in down: about 28% clay, moderate plasticity when wet, light brownish gray when moist. Promising
- Loamy layerH3 A gravelly silty clay loam layer about 32 to 60 in down: about 28% clay, moderate plasticity when wet, light brownish gray when moist. Possible
What it looks like raw
The loamy layer (H2), 16 to 32 in down in the typical profile: light brownish gray (2.5Y 6/2); very friable. Raw colour is not fired colour.
About the soil
- Parent material: mixed alluvium derived from limestone, sandstone, and shale.
- USDA family mineralogy: mixed.
- USDA family particle-size class: fine-silty.
- Drainage: somewhat poorly drained.
- Lithic bedrock typically about 79 in (201 cm) down.
Where it is mapped
Seen on the map as the most common soil in 3 map units in Pennsylvania, in these survey areas: Huntingdon County, Pennsylvania; Lancaster County, Pennsylvania.
By state: wild clay in Pennsylvania.
USDA, distribution and extent: Kentucky, Tennessee, Indiana, Maryland, Ohio, Pennsylvania, West Virginia, southern Missouri, and possibly Arkansas. The soil is of large extent.
USDA, geographic setting: Nearly level flood plains and in upland depressions. Slopes range from 0 to 3 percent. The soils formed in mixed alluvium derived from limestone, shale, siltstone, sandstone, and loess. Near the type location the mean annual temperature is 56.9 degrees F. and the mean annual precipitation is 46.3 inches.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Edom: Strong lead
- Hagerstown: Strong lead
- Hublersburg: Strong lead
- Opequon: Strong lead
- Purdy: Strong lead
- Watchung: Strong lead
- Baile: Promising
- Bowmansville: Promising
See it on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 85%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Newark silt loam, map unit Nc in Lancaster County, Pennsylvania.
- Official Series Description: Newark(revised 03/2007), established.
- Taxonomic class: Fine-silty, mixed, active, nonacid, mesic Fluventic Endoaquepts
- Rated with rule version 2026-09-28.1; the method is on the About page.