Nansene soil
Wild-clay potential
Weak indication
Weak indication: no layer of Nansene shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Nansene soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Nansene spot on the map
Rated from the USDA soil survey record for Nansene silt loam, 30 to 40 percent slopes (Asotin County Area, Washington (Asotin and Garfield Counties)) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Lowers the potential Too little clay to be a clay body on its own: about 14% clay.
- Lowers the potential Low engineering plasticity index (2.5): little plastic behavior expected when wet.
- Note The official series description calls the wet soil slightly sticky and slightly plastic.
- Note Thick enough to investigate (about 27 in (69 cm)).
- Note Typically starts within about 17 in (43 cm) of the surface.
- Note Few rock fragments (about 4% by volume).
Layer by layer
- Sandy layerH1 A silt loam layer about 0 to 17 in down: about 14% clay, low plasticity when wet, very dark brown when moist. Weak indication
- Sandy layerH2best layer A silt loam layer about 17 to 44 in down: about 14% clay, low plasticity when wet, very dark brown when moist. Weak indication
- Sandy layerH3 A silt loam layer about 44 to 60 in down: about 14% clay, low plasticity when wet, dark brown when moist. Weak indication
What it looks like raw
The sandy layer (H2), 17 to 44 in down in the typical profile: very dark brown (10YR 2/2), brown (10YR 4/3) dry; slightly hard, very friable, slightly sticky and slightly plastic. Raw colour is not fired colour.
About the soil
- Parent material: loess.
- USDA family mineralogy: mixed.
- USDA family particle-size class: coarse-silty.
- Drainage: well drained.
Where it is mapped
Seen on the map as the most common soil in 2 map units in Washington, in these survey areas: Asotin County Area, Washington (Asotin and Garfield Counties).
By state: wild clay in Washington.
USDA, distribution and extent: North-central Oregon and southeastern Washington; MLRA 8. This series is of moderate extent.
USDA, geographic setting: The Nansene soils have north-facing slopes and are on canyon side slopes, hillslopes, and plateaus. Slopes are 2 to 70 percent. Elevation is 200 to 2,700 feet. The soils formed in loess. The climate is characterized by cool wet winters and hot dry summers. The mean winter temperature is 33 to 37 degrees F.; the mean summer temperature is 63 to 67 degrees F. The mean annual temperature is 48 to 52 degrees F. The mean annual precipitation is 11 to 15 inches. The frost-free period is 135 to 180 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Cloverland: Strong lead
- Weissenfels: Promising
- Alpowa: Weak indication
- Asotin: Weak indication
- Bolicker: Weak indication
- Bridgewater: Weak indication
- Chard: Weak indication
- Dallesport: Weak indication
See it on the map
Open a Nansene spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 100%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
- Parts of the Official Series Description could not be interpreted; open the original for the complete text.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Nansene silt loam, 30 to 40 percent slopes, map unit 70 in Asotin County Area, Washington (Asotin and Garfield Counties).
- Official Series Description: Nansene(revised 11/2008), established.
- Taxonomic class: Coarse-silty, mixed, superactive, mesic Pachic Haploxerolls
- Rated with rule version 2026-09-28.1; the method is on the About page.