Monongahela soil
Wild-clay potential
Possible
Possible: a clay-enriched layer typically about 6 to 23 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Monongahela soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Monongahela spot on the map
Rated from the USDA soil survey record for Monongahela loam, 3 to 8 percent slopes (Cabell County, West Virginia) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Note Loamy layer with some clay: about 18% clay. It may need settling or refining to become a clay body.
- Note USDA labels this a "Bt1+Bt2" horizon: a subsoil layer where clay has accumulated.
- Note Moderate engineering plasticity index (10).
- Note Thick enough to investigate (about 17 in (43 cm)).
- Note Typically starts within about 6 in (15 cm) of the surface.
- Note Few rock fragments (about 13% by volume).
Layer by layer
- TopsoilAp A loam layer about 0 to 6 in down: about 19% clay, low plasticity when wet, dark grayish brown when moist. Weak indication
- Clay subsoilBt1+Bt2best layer A loam layer about 6 to 23 in down: about 18% clay, moderate plasticity when wet, yellowish brown when moist. Possible
- Sandy layerBx1+Bx2 A loam layer about 23 to 56 in down: about 16% clay, moderate plasticity when wet, light yellowish brown when moist. Weak indication
- Loamy layerC A silt loam layer about 56 to 65 in down: about 23% clay, moderate plasticity when wet, mixed strong brown when moist. Weak indication
What it looks like raw
The clay subsoil (Bt1+Bt2), 6 to 23 in down in the typical profile: yellowish brown (10YR 5/6); friable. Raw colour is not fired colour.
About the soil
- Parent material: fine-loamy alluvium derived from sedimentary rock.
- USDA family mineralogy: mixed.
- USDA family particle-size class: fine-loamy.
- Drainage: moderately well drained.
Where it is mapped
Seen on the map as the most common soil in 6 map units in Pennsylvania, West Virginia, in these survey areas: Berks County, Pennsylvania; Cabell County, West Virginia; Huntingdon County, Pennsylvania; Lehigh County, Pennsylvania.
By state: wild clay in Pennsylvania,wild clay in West Virginia.
USDA, distribution and extent: Distribution: Pennsylvania, West Virginia, Maryland, Ohio, Kentucky, Virginia, Tennessee and Alabama.
USDA, geographic setting: Landscape: River Valleys
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Edom: Strong lead
- Hagerstown: Strong lead
- Hublersburg: Strong lead
- Opequon: Strong lead
- Purdy: Strong lead
- Vandalia: Strong lead
- Brinkerton: Promising
- Bowmansville: Promising
See it on the map
Open a Monongahela spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 100%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Monongahela loam, 3 to 8 percent slopes, map unit MoB in Cabell County, West Virginia.
- Official Series Description: Monongahela(revised 11/2014), established.
- Taxonomic class: Fine-loamy, mixed, semiactive, mesic Typic Fragiudults
- Rated with rule version 2026-09-28.1; the method is on the About page.