Vandalia soil
Wild-clay potential
Strong lead
Strong lead: a clay-enriched layer typically about 13 to 31 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Vandalia soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Vandalia spot on the map
Rated from the USDA soil survey record for Vandalia silt loam, 15 to 25 percent slopes (Cabell County, West Virginia) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Raises the potential Clayey layer: about 35% clay in the fine-earth portion.
- Note USDA labels this a "Bt1" horizon: a subsoil layer where clay has accumulated.
- Raises the potential High engineering plasticity index (24): USDA's estimate suggests plastic behavior when wet.
- Raises the potential The official series description calls the wet soil moderately sticky and moderately plastic (a field observation, not a ceramic test).
- Note Thick enough to investigate (about 18 in (46 cm)).
- Note Typically starts within about 13 in (33 cm) of the surface.
- Note Few rock fragments (about 5% by volume).
Layer by layer
- TopsoilAp A silt loam layer about 0 to 6 in down: about 23% clay, moderate plasticity when wet, brown when moist. Possible
- Loamy layerBA A silt loam layer about 6 to 13 in down: about 24% clay, moderate plasticity when wet, reddish brown when moist. Possible
- Clay subsoilBt1best layer A silty clay loam layer about 13 to 31 in down: about 35% clay, high plasticity when wet, yellowish red when moist. Strong lead
- Clay subsoilBt2 A parachannery silty clay layer about 31 to 46 in down: about 42% clay, high plasticity when wet, reddish brown when moist. Promising
- Clay subsoilBt3 A parachannery silty clay layer about 46 to 54 in down: about 43% clay, high plasticity when wet, reddish brown when moist. Promising
- Clay-rich layerC A very parachannery silty clay loam layer about 54 to 65 in down: about 35% clay, high plasticity when wet, weak red when moist. Weak indication
What it looks like raw
The clay subsoil (Bt1), 13 to 31 in down in the typical profile: yellowish red (5YR 5/6); silty clay loam; firm, moderately sticky and moderately plastic. Raw colour is not fired colour.
About the soil
- Parent material: colluvium derived from sandstone and siltstone.
- USDA family mineralogy: mixed.
- USDA family particle-size class: fine.
- Drainage: well drained.
Where it is mapped
Seen on the map as the most common soil in 1 map unit in West Virginia, in these survey areas: Cabell County, West Virginia.
By state: wild clay in West Virginia.
USDA, distribution and extent: Distribution: Ohio, Kentucky, and West Virginia
USDA, geographic setting: MLRA(s) using this series: 124, 126
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Guyan: Promising
- Allegheny: Possible
- Chagrin: Possible
- Cotaco: Possible
- Dormont: Possible
- Gilpin: Possible
- Kanawha: Possible
- Lobdell: Possible
See it on the map
Open a Vandalia spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 80%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Vandalia silt loam, 15 to 25 percent slopes, map unit VaD in Cabell County, West Virginia.
- Official Series Description: Vandalia(revised 09/2015), established.
- Taxonomic class: Fine, mixed, active, mesic Typic Hapludalfs
- Rated with rule version 2026-09-28.1; the method is on the About page.