Dormont soil
Wild-clay potential
Possible
Possible: a clay-enriched layer typically about 6 to 51 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Dormont soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Dormont spot on the map
Rated from the USDA soil survey record for Dormont silt loam, loamy substratum, 15 to 25 percent slopes (Cabell County, West Virginia) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Raises the potential Clay-enriched layer: about 30% clay in the fine-earth portion.
- Note USDA labels this a "Bt1-4" horizon: a subsoil layer where clay has accumulated.
- Raises the potential High engineering plasticity index (21): USDA's estimate suggests plastic behavior when wet.
- Raises the potential The official series description calls the wet soil moderately sticky and moderately plastic (a field observation, not a ceramic test).
- Note Thick enough to investigate (about 45 in (115 cm)).
- Note Typically starts within about 6 in (15 cm) of the surface.
- Lowers the potential Noticeable rock fragments (about 27% by volume); screening would be needed and the clay percentage applies to the fine earth only.
Layer by layer
- TopsoilAp A silt loam layer about 0 to 6 in down: about 23% clay, moderate plasticity when wet, brown when moist. Weak indication
- Clay subsoilBt1-4best layer A channery silty clay loam layer about 6 to 51 in down: about 30% clay, high plasticity when wet, pale brown when moist. Possible
- Clay-rich layerC A channery clay loam layer about 51 to 65 in down: about 35% clay, high plasticity when wet, light yellowish brown when moist. Possible
What it looks like raw
The clay subsoil (Bt1-4), 6 to 51 in down in the typical profile: pale brown (10YR 6/3); firm, moderately sticky, moderately plastic. Raw colour is not fired colour.
About the soil
- Parent material: fine-loamy colluvium derived from interbedded sedimentary rock.
- USDA family mineralogy: mixed.
- USDA family particle-size class: fine-loamy.
- Drainage: moderately well drained.
Where it is mapped
Seen on the map as the most common soil in 1 map unit in West Virginia, in these survey areas: Cabell County, West Virginia.
By state: wild clay in West Virginia.
USDA, distribution and extent: Distribution: Southwestern Pennsylvania and West Virginia
USDA, geographic setting: MLRA(s): 125 (Cumberland Plateau and Mountains), 126 (Central Allegheny Plateau), 127 (Eastern Allegheny Plateau and Mountains)
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Vandalia: Strong lead
- Guyan: Promising
- Allegheny: Possible
- Chagrin: Possible
- Cotaco: Possible
- Gilpin: Possible
- Kanawha: Possible
- Lobdell: Possible
See it on the map
Open a Dormont spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 100%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Dormont silt loam, loamy substratum, 15 to 25 percent slopes, map unit DoD in Cabell County, West Virginia.
- Official Series Description: Dormont(revised 04/2025), established.
- Taxonomic class: Fine-loamy, mixed, superactive, mesic Oxyaquic Hapludalfs
- Rated with rule version 2026-09-28.1; the method is on the About page.