Allegheny soil
Wild-clay potential
Possible
Possible: a clay-enriched layer typically about 8 to 36 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Allegheny soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Allegheny spot on the map
Rated from the USDA soil survey record for Allegheny, bedrock substratum-Urban land complex, 3 to 15 percent slopes (Cabell County, West Virginia) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Note Loamy layer with some clay: about 27% clay. It may need settling or refining to become a clay body.
- Note USDA labels this a "Bt1+Bt2+BC" horizon: a subsoil layer where clay has accumulated.
- Note Moderate engineering plasticity index (7.5).
- Note Thick enough to investigate (about 28 in (71 cm)).
- Note Typically starts within about 8 in (20 cm) of the surface.
- Note Few rock fragments (about 9% by volume).
Layer by layer
- TopsoilAp A loam layer about 0 to 8 in down: about 21% clay, low plasticity when wet, dark yellowish brown when moist. Weak indication
- Clay subsoilBt1+Bt2+BCbest layer A loam layer about 8 to 36 in down: about 27% clay, moderate plasticity when wet, yellowish brown when moist. Possible
- Loamy layerC A sandy loam layer about 36 to 50 in down: about 19% clay, moderate plasticity when wet, yellowish brown when moist. Possible
- BedrockR Bedrock about 50 to 54 in down: no clay layer to dig. Weak indication
What it looks like raw
The clay subsoil (Bt1+Bt2+BC), 8 to 36 in down in the typical profile: yellowish brown (10YR 5/6). Raw colour is not fired colour.
About the soil
- Parent material: fine-loamy alluvium derived from sedimentary rock.
- USDA family mineralogy: mixed.
- USDA family particle-size class: fine-loamy.
- Drainage: well drained.
- Lithic bedrock typically about 50 in (127 cm) down.
Where it is mapped
Seen on the map as the most common soil in 1 map unit in West Virginia, in these survey areas: Cabell County, West Virginia.
By state: wild clay in West Virginia.
USDA, distribution and extent: Distribution: The Eastern Kentucky Coalfields, Bluegrass, and Knobs regions of Kentucky and similar areas in Arkansas, Maryland, Ohio, Pennsylvania, Tennessee, Virginia and West Virginia
USDA, geographic setting: Landscape: River valleys
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Vandalia: Strong lead
- Guyan: Promising
- Chagrin: Possible
- Cotaco: Possible
- Dormont: Possible
- Gilpin: Possible
- Kanawha: Possible
- Lobdell: Possible
See it on the map
Open a Allegheny spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 41%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Allegheny, bedrock substratum-Urban land complex, 3 to 15 percent slopes, map unit AhC in Cabell County, West Virginia.
- Official Series Description: Allegheny(revised 11/2019), established.
- Taxonomic class: Fine-loamy, mixed, semiactive, mesic Typic Hapludults
- Rated with rule version 2026-09-28.1; the method is on the About page.