Cotaco soil
Wild-clay potential
Possible
Possible: a clay-enriched layer typically about 15 to 45 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Cotaco soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Rated from the USDA soil survey record for Cotaco silt loam, 3 to 8 percent slopes (Cabell County, West Virginia) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Note Loamy layer with some clay: about 27% clay. It may need settling or refining to become a clay body.
- Note USDA labels this a "Bt1+Bt2+BC" horizon: a subsoil layer where clay has accumulated.
- Note Moderate engineering plasticity index (7.5).
- Note Thick enough to investigate (about 30 in (76 cm)).
- Note Typically starts within about 15 in (38 cm) of the surface.
- Note Few rock fragments (about 7% by volume).
Layer by layer
- TopsoilAp+AB A silt loam layer about 0 to 15 in down: about 17% clay, low plasticity when wet, dark grayish brown when moist. Weak indication
- Clay subsoilBt1+Bt2+BCbest layer A loam layer about 15 to 45 in down: about 27% clay, moderate plasticity when wet, grayish brown when moist. Possible
- Loamy layerC A loam layer about 45 to 65 in down: about 27% clay, moderate plasticity when wet, yellowish brown when moist. Possible
What it looks like raw
The clay subsoil (Bt1+Bt2+BC), 15 to 45 in down in the typical profile: grayish brown (2.5Y 5/2); friable. Raw colour is not fired colour.
About the soil
- Parent material: fine-loamy alluvium derived from sedimentary rock.
- USDA family mineralogy: mixed.
- USDA family particle-size class: fine-loamy.
- Drainage: moderately well drained.
Where it is mapped
Seen on the map as the most common soil in 1 map unit in West Virginia, in these survey areas: Cabell County, West Virginia.
By state: wild clay in West Virginia.
USDA, distribution and extent: Primarily the Cumberland and Allegheny Plateaus in Kentucky, Tennessee, Virginia, and West Virginia, and the Northern Appalachian Ridges and Valleys in Virginia. Extent is moderate.
USDA, geographic setting: Foot slopes, colluvial fans, and low stream terraces with slopes of 0 to 20 percent. The regolith is alluvium of acid sandstone, siltstone, and shale origin. Near the type location, the average annual precipitation is 42 to 54 inches, and average annual air temperature is 47 to 57 degrees F.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Vandalia: Strong lead
- Guyan: Promising
- Allegheny: Possible
- Chagrin: Possible
- Dormont: Possible
- Gilpin: Possible
- Kanawha: Possible
- Lobdell: Possible
See it on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 100%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Cotaco silt loam, 3 to 8 percent slopes, map unit CtB in Cabell County, West Virginia.
- Official Series Description: Cotaco(revised 04/2002), established.
- Taxonomic class: Fine-loamy, mixed, semiactive, mesic Aquic Hapludults
- Rated with rule version 2026-09-28.1; the method is on the About page.