Klinesville soil
Wild-clay potential
Weak indication
Weak indication: no layer of Klinesville shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Klinesville soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Klinesville spot on the map
Rated from the USDA soil survey record for Klinesville channery silt loam, 3 to 8 percent slopes, moderately eroded (Carbon County, Pennsylvania) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Lowers the potential Too little clay to be a clay body on its own: about 15% clay.
- Lowers the potential Low engineering plasticity index (3.5): little plastic behavior expected when wet.
- Lowers the potential The official series description calls the wet soil nonsticky and nonplastic.
- Note Thick enough to investigate (about 25 in (64 cm)).
- Note Typically starts within about 15 in (38 cm) of the surface.
- Lowers the potential High rock content (about 63% by volume) lowers its practical promise; the clay percentage applies only to the fine earth between the rocks.
Layer by layer
- Sandy layerH1 A channery silt loam layer about 0 to 5 in down: about 18% clay, low plasticity when wet, dark reddish brown when moist. Weak indication
- Sandy layerH2 A channery silt loam layer about 5 to 15 in down: about 15% clay, low plasticity when wet, reddish brown when moist. Weak indication
- Sandy layerH3best layer An extremely channery silt loam layer about 15 to 40 in down: about 15% clay, low plasticity when wet, reddish brown when moist. Weak indication
- BedrockR Unweathered bedrock about 40 to 44 in down: no clay layer to dig. Weak indication
What it looks like raw
The sandy layer (H3), 15 to 40 in down in the typical profile: reddish brown (2.5YR 4/4); friable, nonsticky, nonplastic. Raw colour is not fired colour.
About the soil
- Parent material: residuum weathered from siltstone.
- USDA family mineralogy: mixed.
- USDA family particle-size class: loamy-skeletal.
- Drainage: somewhat excessively drained.
- Lithic bedrock typically about 40 in (102 cm) down.
Where it is mapped
Seen on the map as the most common soil in 22 map units in Pennsylvania, in these survey areas: Berks County, Pennsylvania; Bucks County, Pennsylvania; Carbon County, Pennsylvania; Huntingdon County, Pennsylvania; Lebanon County, Pennsylvania; Montgomery County, Pennsylvania.
By state: wild clay in Pennsylvania.
USDA, distribution and extent: Eastern and central Pennsylvania, Maryland, New Jersey, and Virginia. The series is of large extent.
USDA, geographic setting: Klinesville soils are gently sloping to very steep upland soils on convex positions. Slopes range from 3 to 80 percent. Klinesville soils formed in weathered reddish shale with some slate, siltstone or fine-grained sandstone. The climate is humid temperate. Mean annual precipitation ranges from 36 to 50 inches, mean annual temperature ranges from 47 to 59 degrees F, and the growing season ranges from 130 to 200 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Hagerstown: Strong lead
- Watchung: Strong lead
- Edom: Strong lead
- Hublersburg: Strong lead
- Opequon: Strong lead
- Purdy: Strong lead
- Bowmansville: Promising
- Mount Lucas: Promising
See it on the map
Open a Klinesville spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 95%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Klinesville channery silt loam, 3 to 8 percent slopes, moderately eroded, map unit KcB2 in Carbon County, Pennsylvania.
- Official Series Description: Klinesville(revised 10/2008), established.
- Taxonomic class: Loamy-skeletal, mixed, active, mesic Lithic Dystrudepts
- Rated with rule version 2026-09-28.1; the method is on the About page.