Mount Lucas soil
Wild-clay potential
Promising
Promising: a clay-enriched layer typically about 12 to 25 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Mount Lucas soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Mount Lucas spot on the map
Rated from the USDA soil survey record for Mount Lucas silt loam, 0 to 3 percent slopes (Montgomery County, Pennsylvania) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Raises the potential Clay-enriched layer: about 29% clay in the fine-earth portion.
- Note USDA labels this a "Bt" horizon: a subsoil layer where clay has accumulated.
- Note Moderate engineering plasticity index (9).
- Note The official series description calls the wet soil slightly sticky and slightly plastic.
- Note Thick enough to investigate (about 13 in (34 cm)).
- Note Typically starts within about 12 in (30 cm) of the surface.
- Note Few rock fragments (about 14% by volume).
Layer by layer
- TopsoilAp A silt loam layer about 0 to 12 in down: about 15% clay, moderate plasticity when wet, yellowish brown when moist. Weak indication
- Clay subsoilBtbest layer A clay loam layer about 12 to 25 in down: about 29% clay, moderate plasticity when wet, strong brown when moist. Promising
- Sandy layerC A gravelly sandy loam layer about 25 to 99 in down: about 13% clay, low plasticity when wet, yellowish red when moist. Weak indication
What it looks like raw
The clay subsoil (Bt), 12 to 25 in down in the typical profile: strong brown (7.5YR 5/6); friable, slightly sticky, slightly plastic. Raw colour is not fired colour.
About the soil
- Parent material: colluvium derived from diabase over residuum weathered from diabase.
- USDA family mineralogy: mixed.
- USDA family particle-size class: fine-loamy.
- Drainage: moderately well drained.
- Lithic bedrock typically about 99 in (251 cm) down.
Where it is mapped
Seen on the map as the most common soil in 32 map units in Delaware, Maryland, Pennsylvania, in these survey areas: Baltimore County, Maryland; Berks County, Pennsylvania; Bucks County, Pennsylvania; Cecil County, Maryland; Chester County, Pennsylvania; Lancaster County, Pennsylvania; Lebanon County, Pennsylvania; Lehigh County, Pennsylvania; Montgomery County, Pennsylvania; New Castle County, Delaware.
By state: wild clay in Delaware,wild clay in Maryland,wild clay in Pennsylvania.
USDA, distribution and extent: Southeastern Pennsylvania, New Jersey, Maryland and Virginia. The series is of moderate extent.
USDA, geographic setting: Mount Lucas soils are nearly level upland flats to steep concave lower slopes. They developed in materials weathered from diabase and other dark colored basic rocks. The climate is humid temperate with mean annual precipitation of 38 to 46 inches, mean annual temperature of 50 to 55 degrees F., and a frost-free season of 170 to 200 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Watchung: Strong lead
- Hagerstown: Strong lead
- Montalto: Strong lead
- Christiana: Strong lead
- Benevola: Strong lead
- Cumberstone: Strong lead
- Jackland: Strong lead
- Lenni: Strong lead
See it on the map
Open a Mount Lucas spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 93%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
- Parts of the Official Series Description could not be interpreted; open the original for the complete text.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Mount Lucas silt loam, 0 to 3 percent slopes, map unit MoA in Montgomery County, Pennsylvania.
- Official Series Description: Mount Lucas(revised 10/2008), established.
- Taxonomic class: Fine-loamy, mixed, superactive, mesic Aquic Hapludalfs
- Rated with rule version 2026-09-28.1; the method is on the About page.