Joppa soil
Wild-clay potential
Weak indication
Weak indication: no layer of Joppa shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Joppa soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Rated from the USDA soil survey record for Joppa gravelly sandy loam, 2 to 5 percent slopes (Harford County Area, Maryland) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Lowers the potential Too little clay to be a clay body on its own: about 5% clay.
- Lowers the potential Low engineering plasticity index (6): little plastic behavior expected when wet.
- Note Thick enough to investigate (about 49 in (125 cm)).
- Note Typically starts within about 23 in (58 cm) of the surface.
- Lowers the potential High rock content (about 51% by volume) lowers its practical promise; the clay percentage applies only to the fine earth between the rocks.
Layer by layer
- Sandy layerH1 A gravelly sandy loam layer about 0 to 13 in down: about 12% clay, moderate plasticity when wet, yellowish red when moist. Weak indication
- Loamy layerH2 A very gravelly sandy loam layer about 13 to 23 in down: about 18% clay, moderate plasticity when wet, reddish brown when moist. Weak indication
- Sandy layerH3best layer A very gravelly loamy sand layer about 23 to 72 in down: about 5% clay, low plasticity when wet, yellowish red when moist. Weak indication
What it looks like raw
The sandy layer (H3), 23 to 72 in down in the typical profile: yellowish red (5YR 4/8); friable. Raw colour is not fired colour.
About the soil
- Parent material: sandy and gravelly fluviomarine deposits.
- USDA family mineralogy: siliceous.
- USDA family particle-size class: loamy-skeletal.
- Drainage: well drained.
Where it is mapped
Seen on the map as the most common soil in 2 map units in Maryland, in these survey areas: Harford County Area, Maryland.
By state: wild clay in Maryland.
USDA, distribution and extent: Maryland, Virginia, Delaware and New Jersey. The series is of large extent.
USDA, geographic setting: Joppa soils are on uplands of the northern Atlantic Coastal Plain near the Piedmont Plateau. Slopes are nearly level to steep, concave and complex. Slopes range from 0 to 50 percent. The soils formed in sandy and gravelly fluvial materials. The mean annual temperature ranges from 50 to 58 degrees F., and the mean annual precipitation ranges from 38 to 45 inches. Frost-free days range from 170 to 210.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Kelly: Strong lead
- Kinkora: Strong lead
- Montalto: Strong lead
- Watchung: Strong lead
- Baile: Promising
- Chester: Promising
- Chillum: Promising
- Chrome: Promising
See it on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 100%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Joppa gravelly sandy loam, 2 to 5 percent slopes, map unit JpB in Harford County Area, Maryland.
- Official Series Description: Joppa(revised 11/2015), established.
- Taxonomic class: Loamy-skeletal, siliceous, semiactive, mesic Typic Hapludults
- Rated with rule version 2026-09-28.1; the method is on the About page.