Kinkora soil
Wild-clay potential
Strong lead
Strong lead: a clayey layer typically about 12 to 30 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Kinkora soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Kinkora spot on the map
Rated from the USDA soil survey record for Kinkora silt loam, 0 to 3 percent slopes (Harford County Area, Maryland) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Raises the potential Clayey layer: about 45% clay in the fine-earth portion.
- Raises the potential High engineering plasticity index (22): USDA's estimate suggests plastic behavior when wet.
- Raises the potential The official series description calls the wet soil moderately sticky and moderately plastic (a field observation, not a ceramic test).
- Note Thick enough to investigate (about 18 in (46 cm)).
- Note Typically starts within about 12 in (30 cm) of the surface.
- Note Few rock fragments (about 4% by volume).
- Note High shrink-swell (linear extensibility about 7.5%): often very plastic, and prone to cracking as it dries.
Layer by layer
- Loamy layerH1 A silt loam layer about 0 to 12 in down: about 21% clay, moderate plasticity when wet, dark grayish brown when moist. Possible
- Clay-rich layerH2best layer A clay layer about 12 to 30 in down: about 45% clay, high plasticity when wet, grayish brown when moist. Strong lead
- Loamy layerH3 A silty clay loam layer about 30 to 36 in down: about 30% clay, moderate plasticity when wet, grayish brown when moist. Promising
- H4 A variable layer about 36 to 60 in down: USDA gives no clay percentage or texture for it. Not enough data
What it looks like raw
The clay-rich layer (H2), 12 to 30 in down in the typical profile: grayish brown (10YR 5/2); firm, moderately sticky, moderately plastic. Raw colour is not fired colour.
About the soil
- Parent material: loamy alluvium from micaceous sediment.
- USDA family mineralogy: mixed.
- USDA family particle-size class: fine.
- Drainage: poorly drained.
- Rated hydric (wetland) soil; often saturated and protected.
Where it is mapped
Seen on the map as the most common soil in 2 map units in Maryland, in these survey areas: Harford County Area, Maryland.
By state: wild clay in Maryland.
USDA, distribution and extent: Virginia, Maryland, Pennsylvania, and North Carolina. The series is of small extent.
USDA, geographic setting: Kinkora soils are level to gently sloping and on stream terraces within the northern Piedmont Plateau and parts of the Blue Ridge Mountains. They also extend locally into limestone valleys, and may extend into the Atlantic Coastal Plain. Slopes range from 0 to 8 percent. The soils formed in old fine-textured alluvium, primarily from areas of acid crystalline rocks. The climate is temperate and humid. Mean annual temperatures range from 7 to 14 degrees C. (45 to 57 degrees F.). Mean annual precipitation ranges from of about 1016 to to 1168 mm (40 to 46 inches).
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Kelly: Strong lead
- Montalto: Strong lead
- Watchung: Strong lead
- Baile: Promising
- Chester: Promising
- Chillum: Promising
- Chrome: Promising
- Delanco: Promising
See it on the map
Open a Kinkora spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 100%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Kinkora silt loam, 0 to 3 percent slopes, map unit KrA in Harford County Area, Maryland.
- Official Series Description: Kinkora(revised 03/2009), established.
- Taxonomic class: Fine, mixed, semiactive, mesic Typic Endoaquults
- Rated with rule version 2026-09-28.1; the method is on the About page.