Haverson soil
Wild-clay potential
Possible
Possible: a loamy layer with some clay typically about 2 to 60 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Haverson soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Haverson spot on the map
Rated from the USDA soil survey record for Haverson loam, 2 to 6 percent slopes (Butte County, South Dakota) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Note Loamy layer with some clay: about 27% clay. It may need settling or refining to become a clay body.
- Note Moderate engineering plasticity index (10).
- Note Thick enough to investigate (about 58 in (147 cm)).
- Note Typically starts within about 2 in (5 cm) of the surface.
- Note Few rock fragments (about 7% by volume).
- Note USDA reports about 8% calcium carbonate; lime in a clay body deserves testing.
Layer by layer
- Loamy layerH1 A loam layer about 0 to 2 in down: about 18% clay, low plasticity when wet, pale brown when moist. Weak indication
- Loamy layerH2best layer A stratified sand to loam to silty clay layer about 2 to 60 in down: about 27% clay, moderate plasticity when wet, pale brown when moist. Possible
What it looks like raw
The loamy layer (H2), 2 to 60 in down in the typical profile: pale brown (10YR 6/3), brown (10YR 4/3) moist; slightly hard, very friable. Raw colour is not fired colour.
About the soil
- Parent material: calcareous loamy alluvium.
- USDA family particle-size class: fine-loamy.
- Drainage: well drained.
Where it is mapped
Seen on the map as the most common soil in 2 map units in South Dakota, in these survey areas: Butte County, South Dakota.
By state: wild clay in South Dakota.
USDA, distribution and extent: Eastern Colorado and Wyoming, northeastern New Mexico and adjacent states. This soil is of large extent.
USDA, geographic setting: The Haverson soils are on floodplains and low terraces of major rivers. Slope is 0 to 9 percent. The soils formed in highly stratified, calcareous, recent alluvium derived from mixed sources. At the type location the average annual precipitation is 14 to 18 inches with peak periods of precipitation occurring during the early spring and summer. The mean annual air temperature ranges from 47 to 52 degrees F. and the mean summer temperature is 77 degrees F. The frost-free season is 125 to 180 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Absher: Strong lead
- Arvada: Strong lead
- Belfield: Strong lead
- Bidman: Strong lead
- Hisle: Strong lead
- Kyle: Strong lead
- McKenzie: Strong lead
- Pierre: Strong lead
See it on the map
Open a Haverson spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 80%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Haverson loam, 2 to 6 percent slopes, map unit HeB in Butte County, South Dakota.
- Official Series Description: Haverson(revised 12/2002), established.
- Taxonomic class: Fine-loamy, mixed, superactive, calcareous, mesic Aridic Ustifluvents
- Rated with rule version 2026-09-28.1; the method is on the About page.