Elk soil
Wild-clay potential
Possible
Possible: a loamy layer with some clay typically about 10 to 48 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Elk soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Rated from the USDA soil survey record for Elk silt loam, 0 to 3 percent slopes (Lancaster County, Pennsylvania) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Note Loamy layer with some clay: about 26% clay. It may need settling or refining to become a clay body.
- Note Moderate engineering plasticity index (10).
- Note Thick enough to investigate (about 38 in (97 cm)).
- Note Typically starts within about 10 in (25 cm) of the surface.
- Note Few rock fragments (about 5% by volume).
Layer by layer
- Loamy layerH1 A silt loam layer about 0 to 10 in down: about 19% clay, low plasticity when wet, brown when moist. Weak indication
- Loamy layerH2best layer A silt loam layer about 10 to 48 in down: about 26% clay, moderate plasticity when wet, brown when moist. Possible
- Loamy layerH3 A gravelly silt loam layer about 48 to 60 in down: about 27% clay, moderate plasticity when wet, yellowish brown when moist. Weak indication
What it looks like raw
The loamy layer (H2), 10 to 48 in down in the typical profile: brown (7.5YR 4/4); friable. Raw colour is not fired colour.
About the soil
- Parent material: mixed alluvium and/or residuum weathered from limestone and siltstone.
- USDA family mineralogy: mixed.
- USDA family particle-size class: fine-silty.
- Drainage: well drained.
- Lithic bedrock typically about 80 in (202 cm) down.
Where it is mapped
Seen on the map as the most common soil in 3 map units in Pennsylvania, in these survey areas: Lancaster County, Pennsylvania.
By state: wild clay in Pennsylvania.
USDA, distribution and extent: Kentucky, Pennsylvania, Maryland, Virginia, West Virginia, and possibly Missouri and Tennessee. Extent is moderate.
USDA, geographic setting: Elk soils are on stream terraces. Slopes commonly range from 0 to 12 percent, but the range allows up to 40 percent. The soils have formed in mixed alluvium from soils developed in residuum from limestone, siltstone, shale, sandstone, or loess. Near the type location, the average annual temperature is 57 degrees F., and the average annual precipitation is 46.3 inches.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Hagerstown: Strong lead
- Watchung: Strong lead
- Baile: Promising
- Bowmansville: Promising
- Bucks: Promising
- Chester: Promising
- Conestoga: Promising
- Duffield: Promising
See it on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 85%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Elk silt loam, 0 to 3 percent slopes, map unit EcA in Lancaster County, Pennsylvania.
- Official Series Description: Elk(revised 02/2026), established.
- Taxonomic class: Fine-silty, mixed, active, mesic Ultic Hapludalfs
- Rated with rule version 2026-09-28.1; the method is on the About page.