Cookport soil
Wild-clay potential
Possible
Possible: a clay-enriched layer typically about 10 to 24 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Cookport soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Cookport spot on the map
Rated from the USDA soil survey record for Cookport silt loam, 0 to 3 percent slopes (Warren and Forest Counties, Pennsylvania) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Note Loamy layer with some clay: about 23% clay. It may need settling or refining to become a clay body.
- Note USDA labels this a "Bt" horizon: a subsoil layer where clay has accumulated.
- Note Moderate engineering plasticity index (15).
- Note Thick enough to investigate (about 14 in (36 cm)).
- Note Typically starts within about 10 in (25 cm) of the surface.
- Note Few rock fragments (about 10% by volume).
Layer by layer
- Organic top layerOi An organic top layer about 0 to 2 in down, not a clay body. Weak indication
- Organic top layerOa An organic top layer about 2 to 3 in down, not a clay body. Weak indication
- TopsoilA A silt loam layer about 3 to 6 in down: about 16% clay, moderate plasticity when wet, dark grayish brown when moist. Weak indication
- Sandy layerE A silt loam layer about 6 to 10 in down: about 17% clay, moderate plasticity when wet, brown when moist. Weak indication
- Clay subsoilBtbest layer A loam layer about 10 to 24 in down: about 23% clay, moderate plasticity when wet, yellowish brown when moist. Possible
- Clay subsoilBtx A channery loam layer about 24 to 40 in down: about 23% clay, moderate plasticity when wet, brown when moist. Weak indication
- Loamy layerC A very channery loam layer about 40 to 60 in down: about 21% clay, moderate plasticity when wet, mixed yellowish brown when moist. Weak indication
- BedrockR Bedrock about 60 to 70 in down: no clay layer to dig. Weak indication
What it looks like raw
The clay subsoil (Bt), 10 to 24 in down in the typical profile: yellowish brown (10YR 5/6); friable. Raw colour is not fired colour.
About the soil
- Parent material: acid fine-loamy residuum weathered from sandstone.
- USDA family mineralogy: mixed.
- USDA family particle-size class: fine-loamy.
- Drainage: moderately well drained.
- Lithic bedrock typically about 60 in (152 cm) down.
Where it is mapped
Seen on the map as the most common soil in 8 map units in Pennsylvania, in these survey areas: Venango County, Pennsylvania; Warren and Forest Counties, Pennsylvania.
By state: wild clay in Pennsylvania.
USDA, distribution and extent: The unglaciated Allegheny Plateau of Pennsylvania, western Maryland and West Virginia. Primarily major land resource area (MLRA) 127, but small areas are in MLRA's 124, 126 and 147. The extent is large.
USDA, geographic setting: Cookport soils are on broad nearly level to gently sloping ridgetops and moderately steep sideslopes. They developed in material weathered from interbedded sandstone, siltstone and in places, a minor component of shale. The climate is humid cool temperate. Average annual precipitation ranges from 1016 to 1524 millimeters and the growing season is 120 to 160 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Cavode: Strong lead
- Armagh: Strong lead
- Ernest: Promising
- Wharton: Promising
- Brinkerton: Promising
- Shelmadine: Promising
- Alvira: Possible
- Atkins: Possible
See it on the map
Open a Cookport spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 85%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
- Parts of the Official Series Description could not be interpreted; open the original for the complete text.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Cookport silt loam, 0 to 3 percent slopes, map unit CtA in Warren and Forest Counties, Pennsylvania.
- Official Series Description: Cookport(revised 04/2025), established.
- Taxonomic class: Fine-loamy, mixed, active, mesic Aquic Fragiudults
- Rated with rule version 2026-09-28.1; the method is on the About page.