Colts Neck soil
Wild-clay potential
Weak indication
Weak indication: no layer of Colts Neck shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Colts Neck soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Colts Neck spot on the map
Rated from the USDA soil survey record for Colts Neck gravelly loam, 5 to 10 percent slopes, severely eroded (Kent County, Maryland) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Note Loamy layer with some clay: about 20% clay. It may need settling or refining to become a clay body.
- Note Moderate engineering plasticity index (10).
- Note Thick enough to investigate (about 27 in (68 cm)).
- Note Typically starts within about 9 in (23 cm) of the surface.
- Lowers the potential Noticeable rock fragments (about 22% by volume); screening would be needed and the clay percentage applies to the fine earth only.
Layer by layer
- Loamy layerH1 A gravelly loam layer about 0 to 9 in down: about 20% clay, moderate plasticity when wet, dark reddish brown when moist. Weak indication
- Loamy layerH2best layer A gravelly sandy clay loam layer about 9 to 36 in down: about 20% clay, moderate plasticity when wet, reddish brown when moist. Weak indication
- Sandy layerH3 A gravelly loamy sand layer about 36 to 52 in down: about 9% clay, low plasticity when wet, reddish brown when moist. Weak indication
What it looks like raw
The loamy layer (H2), 9 to 36 in down in the typical profile: reddish brown (5YR 4/4), yellowish red (5YR 4/8) dry. Raw colour is not fired colour.
About the soil
- USDA family mineralogy: mixed.
- USDA family particle-size class: fine-loamy.
- Drainage: well drained.
Where it is mapped
Seen on the map as the most common soil in 3 map units in Maryland, in these survey areas: Kent County, Maryland.
By state: wild clay in Maryland.
USDA, geographic setting: Landscape: Coastal Plain
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Nanticoke: Promising
- Matapeake: Possible
- Mattapex: Possible
- Sassafras: Possible
- Woodstown: Possible
- Puckum: Weak indication
- Zekiah: Weak indication
- Benevola: Strong lead(same state)
See it on the map
Open a Colts Neck spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 100%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Colts Neck gravelly loam, 5 to 10 percent slopes, severely eroded, map unit CgC3 in Kent County, Maryland.
- Official Series Description: Colts Neck(revised 11/2015), established.
- Taxonomic class: Fine-loamy, mixed, active, mesic Humic Hapludults
- Rated with rule version 2026-09-28.1; the method is on the About page.