Nanticoke soil
Wild-clay potential
Promising
Promising: a loamy layer with some clay typically about 24 to 80 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Nanticoke soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Nanticoke spot on the map
Rated from the USDA soil survey record for Nanticoke and Mannington soils, frequently flooded (Charles County, Maryland) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Raises the potential Clay-enriched layer: about 31% clay in the fine-earth portion.
- Note Moderate engineering plasticity index (15).
- Raises the potential The official series description calls the wet soil moderately sticky and moderately plastic (a field observation, not a ceramic test).
- Note Thick enough to investigate (about 56 in (142 cm)).
- Note Typically starts about 24 in (61 cm) down; expect real digging or look for cuts and banks.
- Missing data Rock fragment content is not reported.
Layer by layer
- TopsoilAg A silt loam layer about 0 to 10 in down: about 12% clay, low plasticity when wet, black when moist. Weak indication
- Loamy layerCg1 A silt loam layer about 10 to 24 in down: about 22% clay, moderate plasticity when wet, dark greenish gray when moist. Possible
- Loamy layerCg2best layer A silty clay loam layer about 24 to 80 in down: about 31% clay, moderate plasticity when wet, dark greenish gray when moist. Promising
What it looks like raw
The loamy layer (Cg2), 24 to 80 in down in the typical profile: dark greenish gray (5GY 4/1); silty clay loam; firm; moderately sticky, moderately plastic. Raw colour is not fired colour.
About the soil
- USDA family mineralogy: mixed.
- USDA family particle-size class: fine-silty.
- Drainage: very poorly drained.
- Rated hydric (wetland) soil; often saturated and protected.
Where it is mapped
Seen on the map as the most common soil in 6 map units in Delaware, Maryland, in these survey areas: Baltimore County, Maryland; Cecil County, Maryland; Charles County, Maryland; Kent County, Maryland; New Castle County, Delaware; Prince George's County, Maryland.
By state: wild clay in Delaware,wild clay in Maryland.
USDA, distribution and extent: Distribution: Coastal Plain of Maryland, Delaware, New Jersey, and Pennsylvania
USDA, geographic setting: Landscape: Coastal Plain
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Christiana: Strong lead
- Lenni: Strong lead
- Montalto: Strong lead
- Watchung: Strong lead
- Magnolia: Strong lead
- Benevola: Strong lead
- Cumberstone: Strong lead
- Howell: Strong lead
See it on the map
Open a Nanticoke spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 60%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Nanticoke and Mannington soils, frequently flooded, map unit NG in Charles County, Maryland.
- Official Series Description: Nanticoke(revised 06/2006), established.
- Taxonomic class: Fine-silty, mixed, active, nonacid, mesic Typic Hydraquents
- Rated with rule version 2026-09-28.1; the method is on the About page.