Magnolia soil
Wild-clay potential
Strong lead
Strong lead: a clay-enriched layer typically about 19 to 66 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Magnolia soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Magnolia spot on the map
Rated from the USDA soil survey record for Magnolia silt loam, 0 to 2 percent slopes (Charles County, Maryland) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Raises the potential Clayey layer: about 42% clay in the fine-earth portion.
- Note USDA labels this a "Bt2" horizon: a subsoil layer where clay has accumulated.
- Raises the potential High engineering plasticity index (20): USDA's estimate suggests plastic behavior when wet.
- Raises the potential The official series description calls the wet soil moderately sticky and moderately plastic (a field observation, not a ceramic test).
- Note Thick enough to investigate (about 47 in (120 cm)).
- Note Typically starts within about 19 in (48 cm) of the surface.
- Note Few rock fragments (about 1% by volume).
Layer by layer
- TopsoilAp A silt loam layer about 0 to 7 in down: about 16% clay, low plasticity when wet, very dark grayish brown when moist. Weak indication
- Clay subsoilBt1 A silt loam layer about 7 to 19 in down: about 24% clay, moderate plasticity when wet, percent brown when moist. Possible
- Clay subsoilBt2best layer A clay layer about 19 to 66 in down: about 42% clay, high plasticity when wet, yellowish red when moist. Strong lead
What it looks like raw
The clay subsoil (Bt2), 19 to 66 in down in the typical profile: yellowish red (5YR 4/6); silt loam; very friable; sticky, plastic. Raw colour is not fired colour.
About the soil
- Parent material: Pliocene age loamy fluviomarine deposits.
- USDA family mineralogy: mixed.
- USDA family particle-size class: fine-loamy.
- Drainage: well drained.
Where it is mapped
Seen on the map as the most common soil in 8 map units in Maryland, in these survey areas: Charles County, Maryland; Prince George's County, Maryland.
By state: wild clay in Maryland.
USDA, geographic setting: Landscape: Coastal Plain, upland
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Lenni: Strong lead
- Christiana: Strong lead
- Howell: Strong lead
- Elkton: Promising
- Liverpool: Promising
- Nanticoke: Promising
- Piccowaxen: Promising
- Aquasco: Promising
See it on the map
Open a Magnolia spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 100%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Magnolia silt loam, 0 to 2 percent slopes, map unit MaA in Charles County, Maryland.
- Official Series Description: Magnolia(revised 11/2019), established.
- Taxonomic class: Fine-loamy, mixed, semiactive, mesic Typic Paleudalfs
- Rated with rule version 2026-09-28.1; the method is on the About page.