Liverpool soil
Wild-clay potential
Promising
Promising: a clay-enriched layer typically about 13 to 35 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Liverpool soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Liverpool spot on the map
Rated from the USDA soil survey record for Liverpool silt loam, 0 to 2 percent slopes (Charles County, Maryland) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Raises the potential Clay-enriched layer: about 35% clay in the fine-earth portion.
- Note USDA labels this a "Bt2" horizon: a subsoil layer where clay has accumulated.
- Note Moderate engineering plasticity index (15).
- Raises the potential The official series description calls the wet soil moderately sticky and very plastic (a field observation, not a ceramic test).
- Note Thick enough to investigate (about 22 in (56 cm)).
- Note Typically starts within about 13 in (33 cm) of the surface.
- Note Few rock fragments (about 0% by volume).
Layer by layer
- TopsoilA A silt loam layer about 0 to 2 in down: about 13% clay, low plasticity when wet, very dark brown when moist. Weak indication
- Sandy layerE A silt loam layer about 2 to 5 in down: about 13% clay, low plasticity when wet, light olive brown when moist. Weak indication
- Clay subsoilBt1 A silt loam layer about 5 to 13 in down: about 20% clay, low plasticity when wet, light yellowish brown when moist. Weak indication
- Clay subsoilBt2best layer A clay loam layer about 13 to 35 in down: about 35% clay, moderate plasticity when wet, yellowish brown when moist. Promising
- Clay subsoilBtg A sandy clay loam layer about 35 to 64 in down: about 25% clay, moderate plasticity when wet, percent light brownish gray when moist. Possible
- Loamy layerBC A sandy clay loam layer about 64 to 74 in down: about 23% clay, moderate plasticity when wet, percent brownish yellow when moist. Weak indication
What it looks like raw
The clay subsoil (Bt2), 13 to 35 in down in the typical profile: yellowish brown (10YR 5/6); silt loam; friable, moderately sticky, very plastic. Raw colour is not fired colour.
About the soil
- Parent material: silty and loamy fluviomarine deposits.
- USDA family mineralogy: mixed.
- USDA family particle-size class: fine-silty.
- Drainage: moderately well drained.
Where it is mapped
Seen on the map as the most common soil in 4 map units in Maryland, in these survey areas: Charles County, Maryland; Prince George's County, Maryland.
By state: wild clay in Maryland.
USDA, distribution and extent: Distribution: Coastal Plain of Southern Maryland; possibly the Delmarva Peninsula.
USDA, geographic setting: Landscape: Coastal plain
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Lenni: Strong lead
- Magnolia: Strong lead
- Christiana: Strong lead
- Howell: Strong lead
- Elkton: Promising
- Nanticoke: Promising
- Piccowaxen: Promising
- Aquasco: Promising
See it on the map
Open a Liverpool spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 80%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Liverpool silt loam, 0 to 2 percent slopes, map unit LsA in Charles County, Maryland.
- Official Series Description: Liverpool(revised 06/2007), established.
- Taxonomic class: Fine-silty, mixed, semiactive, mesic Aquic Hapludults
- Rated with rule version 2026-09-28.1; the method is on the About page.