Zekiah soil
Wild-clay potential
Weak indication
Weak indication: no layer of Zekiah shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Zekiah soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Rated from the USDA soil survey record for Zekiah silt loam, 0 to 2 percent slopes, frequently flooded (Kent County, Maryland) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Lowers the potential Too little clay to be a clay body on its own: about 2% clay.
- Lowers the potential Low engineering plasticity index (0): little plastic behavior expected when wet.
- Note The official series description calls the wet soil slightly sticky and slightly plastic.
- Note Thick enough to investigate (about 30 in (76 cm)).
- Lowers the potential Typically starts about 50 in (127 cm) down, deeper than most hand digging.
- Note Few rock fragments (about 10% by volume).
Layer by layer
- TopsoilA A silt loam layer about 0 to 3 in down: about 14% clay, moderate plasticity when wet, dark brown when moist. Weak indication
- Sandy layerCg A silt loam layer about 3 to 20 in down: about 14% clay, moderate plasticity when wet, dark grayish brown when moist. Weak indication
- Topsoil2Ab A sandy loam layer about 20 to 27 in down: about 6% clay, low plasticity when wet, very dark gray when moist. Weak indication
- Sandy layer2Cg1 A sandy loam layer about 27 to 50 in down: about 8% clay, low plasticity when wet, dark grayish brown when moist. Weak indication
- Sandy layer2Cg2best layer A stratified sand to sandy loam layer about 50 to 80 in down: about 2% clay, low plasticity when wet, dark grayish brown when moist. Weak indication
What it looks like raw
The sandy layer (2Cg2), 50 to 80 in down in the typical profile: dark grayish brown (10YR 4/2); friable, slightly sticky, slightly plastic. Raw colour is not fired colour.
About the soil
- Parent material: loamy alluvium over fluvial coarse-loamy alluvium.
- USDA family mineralogy: siliceous.
- USDA family particle-size class: coarse-loamy.
- Drainage: poorly drained.
- Rated hydric (wetland) soil; often saturated and protected.
Where it is mapped
Seen on the map as the most common soil in 4 map units in Maryland, in these survey areas: Cecil County, Maryland; Harford County, Aberdeen Proving Ground, Maryland; Kent County, Maryland; Prince George's County, Maryland.
By state: wild clay in Maryland.
USDA, geographic setting: Landscape: Coastal Plain
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Christiana: Strong lead
- Lenni: Strong lead
- Howell: Strong lead
- Magnolia: Strong lead
- Montalto: Strong lead
- Watchung: Strong lead
- Elkton: Promising
- Nanticoke: Promising
See it on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 80%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Zekiah silt loam, 0 to 2 percent slopes, frequently flooded, map unit Zk in Kent County, Maryland.
- Official Series Description: Zekiah(revised 11/2015), established.
- Taxonomic class: Coarse-loamy, siliceous, active, acid, mesic Typic Fluvaquents
- Rated with rule version 2026-09-28.1; the method is on the About page.