Braceville soil
Wild-clay potential
Weak indication
Weak indication: no layer of Braceville shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Braceville soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Braceville spot on the map
Rated from the USDA soil survey record for Braceville gravelly silt loam, 0 to 8 percent slopes (Warren and Forest Counties, Pennsylvania) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Lowers the potential Too little clay to be a clay body on its own: about 4% clay.
- Lowers the potential Low engineering plasticity index (2.5): little plastic behavior expected when wet.
- Note Thick enough to investigate (about 25 in (63 cm)).
- Note Typically starts about 35 in (89 cm) down; expect real digging or look for cuts and banks.
- Lowers the potential High rock content (about 40% by volume) lowers its practical promise; the clay percentage applies only to the fine earth between the rocks.
Layer by layer
- TopsoilAp A gravelly silt loam layer about 0 to 10 in down: about 18% clay, low plasticity when wet, dark grayish brown when moist. Weak indication
- Sandy layerBw A gravelly silt loam layer about 10 to 20 in down: about 18% clay, low plasticity when wet, yellowish brown when moist. Weak indication
- Sandy layerBx A gravelly loam layer about 20 to 35 in down: about 18% clay, low plasticity when wet, brown when moist. Weak indication
- Sandy layerCbest layer A stratified sand and gravel layer about 35 to 60 in down: about 4% clay, low plasticity when wet, grayish brown when moist. Weak indication
What it looks like raw
The sandy layer (C), 35 to 60 in down in the typical profile: grayish brown (2.5Y 5/2); stratified sand and gravel. Raw colour is not fired colour.
About the soil
- Parent material: outwash.
- USDA family mineralogy: mixed.
- USDA family particle-size class: coarse-loamy.
- Drainage: moderately well drained.
Where it is mapped
Seen on the map as the most common soil in 1 map unit in Pennsylvania, in these survey areas: Warren and Forest Counties, Pennsylvania.
By state: wild clay in Pennsylvania.
USDA, distribution and extent: Northern Pennsylvania, southern New York, New Jersey. MLRA's 139, 140, and 144A. Series is of moderate extent.
USDA, geographic setting: Braceville soils are nearly level to moderately steep soils on terraces, beaches, fans, and moraines. Slopes range from 0 to 15 percent. The soils formed in glacial outwash of stratified sand, silt, and gravel derived largely from noncalcareous gray sandstone and shale, but may contain small amounts of reddish rocks and limestone. Some pedons have a thin silty mantle. Climate is humid and temperate, with mean annual precipitation of 900 to 1290 centimeters; average annual air temperature of 8.5 to 10 degrees C., and the growing season is 140 to 170 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Armagh: Strong lead
- Cavode: Strong lead
- Brinkerton: Promising
- Ernest: Promising
- Shelmadine: Promising
- Wharton: Promising
- Alvira: Possible
- Atkins: Possible
See it on the map
Open a Braceville spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 90%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Braceville gravelly silt loam, 0 to 8 percent slopes, map unit BcB in Warren and Forest Counties, Pennsylvania.
- Official Series Description: Braceville(revised 04/2025), established.
- Taxonomic class: Coarse-loamy, mixed, active, mesic Typic Fragiudepts
- Rated with rule version 2026-09-28.1; the method is on the About page.