Blairton soil
Wild-clay potential
Possible
Possible: a loamy layer with some clay typically about 9 to 22 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Blairton soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Blairton spot on the map
Rated from the USDA soil survey record for Blairton silt loam, 2 to 8 percent slopes (Huntingdon County, Pennsylvania) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Raises the potential Clay-enriched layer: about 28% clay in the fine-earth portion.
- Note Moderate engineering plasticity index (11).
- Raises the potential The official series description calls the wet soil moderately sticky and moderately plastic (a field observation, not a ceramic test).
- Note Thick enough to investigate (about 13 in (33 cm)).
- Note Typically starts within about 9 in (23 cm) of the surface.
- Lowers the potential Noticeable rock fragments (about 34% by volume); screening would be needed and the clay percentage applies to the fine earth only.
Layer by layer
- Loamy layerH1 A silt loam layer about 0 to 9 in down: about 19% clay, low plasticity when wet, dark grayish brown when moist. Weak indication
- Loamy layerH2best layer A channery silty clay loam layer about 9 to 22 in down: about 28% clay, moderate plasticity when wet, yellowish brown when moist. Possible
- Loamy layerH3 A very channery loam layer about 22 to 26 in down: about 19% clay, moderate plasticity when wet, yellowish brown when moist. Weak indication
- BedrockH4 Bedrock about 26 to 30 in down: no clay layer to dig. Weak indication
What it looks like raw
The loamy layer (H2), 9 to 22 in down in the typical profile: yellowish brown (10YR 5/6); firm, sticky, plastic. Raw colour is not fired colour.
About the soil
- Parent material: local silty colluvium derived from shale and siltstone over acid silty residuum weathered from shale and siltstone.
- USDA family mineralogy: mixed.
- USDA family particle-size class: fine-loamy.
- Drainage: somewhat poorly drained.
- Lithic bedrock typically about 26 in (66 cm) down.
Where it is mapped
Seen on the map as the most common soil in 3 map units in Pennsylvania, in these survey areas: Huntingdon County, Pennsylvania; Lancaster County, Pennsylvania.
By state: wild clay in Pennsylvania.
USDA, distribution and extent: Pennsylvania, Ohio, Virginia, and West Virginia. The series is of moderate extent.
USDA, geographic setting: Blairton soils are nearly level to moderately steep soils on upland flats, depressions, and in drainage heads. Slope gradients are dominantly between 2 and 8 percent but range from 0 to 35 percent. The soils formed in residuum weathered from noncalcareous gray shale and some sandstone. Climate is humid and temperate; mean annual precipitation ranges from 36 to 46 inches; mean annual temperature ranges from 50 to 55 degrees F.; the growing season ranges from 150 to 190 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Edom: Strong lead
- Hagerstown: Strong lead
- Hublersburg: Strong lead
- Opequon: Strong lead
- Purdy: Strong lead
- Watchung: Strong lead
- Newark: Promising
- Baile: Promising
See it on the map
Open a Blairton spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 90%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Blairton silt loam, 2 to 8 percent slopes, map unit BoB in Huntingdon County, Pennsylvania.
- Official Series Description: Blairton(revised 05/2003), established.
- Taxonomic class: Fine-loamy, mixed, active, mesic Aquic Hapludults
- Rated with rule version 2026-09-28.1; the method is on the About page.