Bingham soil
Wild-clay potential
Possible
Possible: a loamy layer with some clay typically about 14 to 23 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Bingham soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Bingham spot on the map
Rated from the USDA soil survey record for Bingham gravelly loam, 3 to 6 percent slopes (Salt Lake Area, Utah) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Raises the potential Clay-enriched layer: about 30% clay in the fine-earth portion.
- Note Moderate engineering plasticity index (10).
- Note The official series description calls the wet soil slightly sticky and slightly plastic.
- Note Moderate thickness (about 9 in (22 cm)).
- Note Typically starts within about 14 in (36 cm) of the surface.
- Lowers the potential Noticeable rock fragments (about 29% by volume); screening would be needed and the clay percentage applies to the fine earth only.
- Note USDA reports about 9% calcium carbonate; lime in a clay body deserves testing.
Layer by layer
- TopsoilAp A gravelly loam layer about 0 to 6 in down: about 23% clay, moderate plasticity when wet, dark grayish brown when moist. Weak indication
- TopsoilA1 A gravelly loam layer about 6 to 10 in down: about 23% clay, moderate plasticity when wet, brown when moist. Weak indication
- Loamy layerB1 A gravelly clay loam layer about 10 to 14 in down: about 30% clay, moderate plasticity when wet, brown when moist. Weak indication
- Loamy layerB2tbest layer A gravelly clay loam layer about 14 to 23 in down: about 30% clay, moderate plasticity when wet, brown when moist. Possible
- Loamy layerB3ca A cobbly clay loam layer about 23 to 35 in down: about 31% clay, moderate plasticity when wet, pale brown when moist. Weak indication
- Sandy layerIIC1ca A very cobbly loamy sand layer about 35 to 60 in down: about 10% clay, low plasticity when wet, pale brown when moist. Weak indication
What it looks like raw
The loamy layer (B2t), 14 to 23 in down in the typical profile: brown (7.5YR 4/3), dark brown (7.5YR 3/3) moist; soft, friable, slightly sticky and slightly plastic. Raw colour is not fired colour.
About the soil
- Parent material: gravelly alluvium.
- USDA family mineralogy: mixed.
- USDA family particle-size class: fine-loamy over sandy or sandy-skeletal.
- Drainage: well drained.
Where it is mapped
Seen on the map as the most common soil in 3 map units in Utah, in these survey areas: Salt Lake Area, Utah.
By state: wild clay in Utah.
USDA, distribution and extent: MLRA 28A. These soils are moderately extensive in north-central Utah and southern Idaho, dominantly along the Wasatch Front.
USDA, geographic setting: Bingham soils are on gently sloping lake terraces and deltaic terraces of old Lake Bonneville and strongly sloping fan remnants with slopes of 1 to 10 percent. Elevation ranges from 4,320 feet to 5,350 feet. They formed in alluvium derived from a mixture of rock, sources, but the gravel is dominantly quartzite. The climate is dry subhumid. Mean annual temperature ranges from 45 to 53 degrees F. Average annual precipitation is 12 to 18 inches (307 to 461 mm) and the freeze-free period is 100 to 180 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Bramwell: Strong lead
- Deckerman: Strong lead
- Eimarsh: Strong lead
- Jordan: Strong lead
- Lasil: Strong lead
- Magna: Strong lead
- Pintailake: Strong lead
- Saltair: Strong lead
See it on the map
Open a Bingham spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 95%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Bingham gravelly loam, 3 to 6 percent slopes, map unit BhB in Salt Lake Area, Utah.
- Official Series Description: Bingham(revised 10/2014), established.
- Taxonomic class: Fine-loamy over sandy or sandy-skeletal, mixed, superactive, mesic Calcic Argixerolls
- Rated with rule version 2026-09-28.1; the method is on the About page.