Bedington soil
Wild-clay potential
Weak indication
Weak indication: no layer of Bedington shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Bedington soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Bedington spot on the map
Rated from the USDA soil survey record for Bedington shaly silt loam, 0 to 3 percent slopes (Lebanon County, Pennsylvania) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Note Loamy layer with some clay: about 25% clay. It may need settling or refining to become a clay body.
- Note Moderate engineering plasticity index (10).
- Note The official series description calls the wet soil slightly sticky and slightly plastic.
- Note Thick enough to investigate (about 33 in (84 cm)).
- Note Typically starts within about 10 in (25 cm) of the surface.
- Lowers the potential High rock content (about 45% by volume) lowers its practical promise; the clay percentage applies only to the fine earth between the rocks.
Layer by layer
- TopsoilA A channery silt loam layer about 0 to 10 in down: about 20% clay, low plasticity when wet, dark brown when moist. Weak indication
- Loamy layerBbest layer A very channery silt loam layer about 10 to 43 in down: about 25% clay, moderate plasticity when wet, yellowish red when moist. Weak indication
- Loamy layerC An extremely channery silt loam layer about 43 to 63 in down: about 25% clay, moderate plasticity when wet, yellowish red when moist. Weak indication
- BedrockR Bedrock about 63 to 73 in down: no clay layer to dig. Weak indication
What it looks like raw
The loamy layer (B), 10 to 43 in down in the typical profile: yellowish red (5YR 5/6); friable, slightly sticky, slightly plastic. Raw colour is not fired colour.
About the soil
- Parent material: fine-loamy residuum weathered from shale and siltstone sedimentary rock.
- USDA family mineralogy: mixed.
- USDA family particle-size class: fine-loamy.
- Drainage: well drained.
- Lithic bedrock typically about 63 in (160 cm) down.
Where it is mapped
Seen on the map as the most common soil in 20 map units in Pennsylvania, in these survey areas: Berks County, Pennsylvania; Bucks County, Pennsylvania; Huntingdon County, Pennsylvania; Lancaster County, Pennsylvania; Lebanon County, Pennsylvania; Lehigh County, Pennsylvania; Northampton County, Pennsylvania.
By state: wild clay in Pennsylvania.
USDA, distribution and extent: Pennsylvania and New Jersey. The series is of large extent.
USDA, geographic setting: Bedington soils are nearly level to steep and are on convex dissected uplands and sideslopes of ridges and hills. Slopes range from 0 to 35 percent. They formed in residuum weathered from acid shale or interbedded shale, siltstone, and fine-grained sandstone. Mean annual precipitation ranges from 35 to 48 inches; mean annual temperature ranges from 45 to 57 degrees F.; mean growing season ranges from 150 to 190 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Hagerstown: Strong lead
- Watchung: Strong lead
- Edom: Strong lead
- Hublersburg: Strong lead
- Opequon: Strong lead
- Purdy: Strong lead
- Bowmansville: Promising
- Brinkerton: Promising
See it on the map
Open a Bedington spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 90%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Bedington shaly silt loam, 0 to 3 percent slopes, map unit BeA in Lebanon County, Pennsylvania.
- Official Series Description: Bedington(revised 02/2002), established.
- Taxonomic class: Fine-loamy, mixed, active, mesic Typic Hapludults
- Rated with rule version 2026-09-28.1; the method is on the About page.