Aldino soil
Wild-clay potential
Possible
Possible: a loamy layer with some clay typically about 36 to 60 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Aldino soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Rated from the USDA soil survey record for Aldino silt loam, 0 to 3 percent slopes (Harford County Area, Maryland) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Note Loamy layer with some clay: about 21% clay. It may need settling or refining to become a clay body.
- Note Moderate engineering plasticity index (10).
- Note The official series description calls the wet soil slightly sticky and slightly plastic.
- Note Thick enough to investigate (about 24 in (61 cm)).
- Note Typically starts about 36 in (91 cm) down; expect real digging or look for cuts and banks.
- Note Few rock fragments (about 14% by volume).
Layer by layer
- Sandy layerH1 A silt loam layer about 0 to 10 in down: about 13% clay, moderate plasticity when wet, brown when moist. Weak indication
- Loamy layerH2 A silt loam layer about 10 to 22 in down: about 25% clay, moderate plasticity when wet, light yellowish brown when moist. Possible
- Loamy layerH3 A silt loam layer about 22 to 36 in down: about 25% clay, moderate plasticity when wet, light yellowish brown when moist. Possible
- Loamy layerH4best layer A loam layer about 36 to 60 in down: about 21% clay, moderate plasticity when wet, light brownish gray when moist. Possible
What it looks like raw
The loamy layer (H4), 36 to 60 in down in the typical profile: light brownish gray (10YR 6/2); very firm, slightly sticky, slightly plastic. Raw colour is not fired colour.
About the soil
- USDA family mineralogy: mixed.
- USDA family particle-size class: fine-silty.
- Drainage: moderately well drained.
Where it is mapped
Seen on the map as the most common soil in 4 map units in Maryland, in these survey areas: Harford County Area, Maryland.
By state: wild clay in Maryland.
USDA, distribution and extent: Maryland, Delaware, Pennsylvania and Virginia. The series is of moderate extent.
USDA, geographic setting: Aldino soils are on uplands of northern portions of the Piedmont Plateau. Slopes range from 0 to 15 percent. The soils formed in materials weathered from serpentine and overlying silt man- tle. The mean annual temperature is about 52 to 57 degrees F., and the mean annual precipitation is about 40 inches.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Kelly: Strong lead
- Kinkora: Strong lead
- Montalto: Strong lead
- Watchung: Strong lead
- Baile: Promising
- Chester: Promising
- Chillum: Promising
- Chrome: Promising
See it on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 95%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Aldino silt loam, 0 to 3 percent slopes, map unit AdA in Harford County Area, Maryland.
- Official Series Description: Aldino(revised 01/2006), inactive.
- Taxonomic class: Fine-silty, mixed, active, mesic Typic Fragiudalfs
- Rated with rule version 2026-09-28.1; the method is on the About page.