Yawdim soil
Wild-clay potential
Strong lead
Strong lead: a clayey layer typically about 2 to 19 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Yawdim soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Rated from the USDA soil survey record for Yawdim silty clay loam, 6 to 9 percent slopes (Meade County, South Dakota, Northern Part) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Raises the potential Clayey layer: about 43% clay in the fine-earth portion.
- Raises the potential High engineering plasticity index (22.5): USDA's estimate suggests plastic behavior when wet.
- Raises the potential The official series description calls the wet soil moderately sticky and moderately plastic (a field observation, not a ceramic test).
- Note Thick enough to investigate (about 17 in (43 cm)).
- Note Typically starts within about 2 in (5 cm) of the surface.
- Missing data Rock fragment content is not reported.
- Note High shrink-swell (linear extensibility about 7.5%): often very plastic, and prone to cracking as it dries.
- Note USDA reports about 9% calcium carbonate; lime in a clay body deserves testing.
Layer by layer
- Loamy layerH1 A silty clay loam layer about 0 to 2 in down: about 34% clay, moderate plasticity when wet, gray when moist. Possible
- Clay-rich layerH2best layer A silty clay layer about 2 to 19 in down: about 43% clay, high plasticity when wet, light brownish gray when moist. Strong lead
- BedrockCr Weathered bedrock about 19 to 60 in down: no clay layer to dig. Weak indication
What it looks like raw
The clay-rich layer (H2), 2 to 19 in down in the typical profile: light brownish gray (2.5Y 6/2), dark grayish brown (2.5Y 4/2) moist; very hard, firm, sticky and plastic. Raw colour is not fired colour.
About the soil
- Parent material: residuum weathered from shale and siltstone.
- USDA family particle-size class: clayey.
- Drainage: well drained.
- Paralithic bedrock typically about 15 in (38 cm) down.
Where it is mapped
Seen on the map as the most common soil in 1 map unit in South Dakota, in these survey areas: Meade County, South Dakota, Northern Part.
By state: wild clay in South Dakota.
USDA, distribution and extent: Eastern Montana, western South Dakota, and western North Dakota. The series is extensive.
USDA, geographic setting: Yawdim soils are on nearly level to very steep sedimentary upland hills and ridges. Slopes range from 2 to 70 percent. The soil formed in alluvium or colluvium over residuum or weathered from calcareous siltstone or shale. The mean annual precipitation is 10 to 16 inches, most of which falls during spring and summer. The mean annual air temperature is 40 to 47 degrees F.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Abor: Strong lead
- Absher: Strong lead
- Gerdrum: Strong lead
- Grail: Strong lead
- Heil: Strong lead
- Hisle: Strong lead
- Kyle: Strong lead
- Lawther: Strong lead
See it on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 90%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Yawdim silty clay loam, 6 to 9 percent slopes, map unit YaC in Meade County, South Dakota, Northern Part.
- Official Series Description: Yawdim(revised 06/2005), established.
- Taxonomic class: Clayey, smectitic, calcareous, frigid, shallow Aridic Ustorthents
- Rated with rule version 2026-09-28.1; the method is on the About page.