Lawther soil
Wild-clay potential
Strong lead
Strong lead: a clayey layer typically about 47 to 79 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Lawther soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Lawther spot on the map
Rated from the USDA soil survey record for Lawther silty clay, 3 to 6 percent slopes (Meade County, South Dakota, Northern Part) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Raises the potential Clayey layer: about 38% clay in the fine-earth portion.
- Raises the potential High engineering plasticity index (25): USDA's estimate suggests plastic behavior when wet.
- Raises the potential The official series description calls the wet soil very sticky and very plastic (a field observation, not a ceramic test).
- Note Thick enough to investigate (about 32 in (81 cm)).
- Note Typically starts about 47 in (119 cm) down; expect real digging or look for cuts and banks.
- Missing data Rock fragment content is not reported.
- Note High shrink-swell (linear extensibility about 6.1%): often very plastic, and prone to cracking as it dries.
- Note USDA reports about 10% calcium carbonate; lime in a clay body deserves testing.
Layer by layer
- Clay-rich layerAp A silty clay layer about 0 to 5 in down: about 43% clay, high plasticity when wet, dark grayish brown when moist. Possible
- Clay-rich layerA A silty clay layer about 5 to 10 in down: about 44% clay, high plasticity when wet, dark grayish brown when moist. Possible
- Clay-rich layerBss A silty clay layer about 10 to 33 in down: about 46% clay, high plasticity when wet, grayish brown when moist. Strong lead
- Clay-rich layerBk A silty clay layer about 33 to 47 in down: about 49% clay, high plasticity when wet, light brownish gray when moist. Strong lead
- Clay-rich layerCbest layer A silty clay loam layer about 47 to 79 in down: about 38% clay, high plasticity when wet, grayish brown when moist. Strong lead
What it looks like raw
The clay-rich layer (C), 47 to 79 in down in the typical profile: grayish brown (2.5Y 5/2), dark grayish brown (2.5Y 4/2) moist; very hard, firm, very sticky and very plastic. Raw colour is not fired colour.
About the soil
- Parent material: slope alluvium derived from calcareous shale.
- USDA family mineralogy: smectitic. Smectite-rich clays are usually very plastic and shrink a lot as they dry.
- USDA family particle-size class: fine.
- Drainage: well drained.
Where it is mapped
Seen on the map as the most common soil in 1 map unit in South Dakota, in these survey areas: Meade County, South Dakota, Northern Part.
By state: wild clay in South Dakota.
USDA, distribution and extent: Southwestern North Dakota, northwestern South Dakota, and eastern Montana. The soil is extensive.
USDA, geographic setting: Lawther soils are on level to sloping uplands, fans and terraces. Slopes are plane or slightly concave. Slope gradients typically range from 0 to 4 percent, but some are as steep as 9 percent. The soil formed in calcareous clayey sediments. The climate is cool, semiarid. Mean annual air temperature ranges from 39 to 45 degrees F, and mean annual precipitation from 13 to 19 inches. Most of the precipitation comes in the spring and summer.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Abor: Strong lead
- Absher: Strong lead
- Gerdrum: Strong lead
- Grail: Strong lead
- Heil: Strong lead
- Hisle: Strong lead
- Kyle: Strong lead
- Loburn: Strong lead
See it on the map
Open a Lawther spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 85%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Lawther silty clay, 3 to 6 percent slopes, map unit LaB in Meade County, South Dakota, Northern Part.
- Official Series Description: Lawther(revised 01/2023), established.
- Taxonomic class: Fine, smectitic, frigid Typic Haplusterts
- Rated with rule version 2026-09-28.1; the method is on the About page.